User manual SONY CDX-S2050

[. . . ] ⷠDo not subject the front panel to heat/high temperature or moisture. Tip You can set the clock automatically with the RDS feature (page 8). With the card remote commander In step 2 and 4, to select the item or setting, press M or m. Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks. [. . . ] With the card remote commander In step 3, to adjust the selected item, press < or , . With the card remote commander In step 2, to select the setup item, press M or m. After 3 seconds, the setting is complete and the display returns to normal play/reception mode. The following items can be set (follow the page reference for details): "z" indicates the default settings. With the card remote commander In step 2, to adjust the selected item, press < or , . You can adjust and store the equalizer settings for different tone ranges. The volume level is adjustable in 1 dB steps, from ­10 dB to +10 dB. After 3 seconds, the setting is complete and the display returns to normal play/reception mode. ) When the battery becomes weak, the range of the card remote commander becomes shorter. Card remote commander RM-X114 location of controls The corresponding buttons on the card remote commander control the same functions as those on this unit. ⷠWipe the battery with a dry cloth to assure a good contact. ⷠBe sure to observe the correct polarity when installing the battery. ⷠDo not hold the battery with metallic tweezers, otherwise a short-circuit may occur. The following buttons on the card remote commander have also different buttons/functions from the unit. (For details of other operations, see "With the card remote commander" on each pages. M/m (DISC*/PRESET +/­) buttons For details, see "With the card remote commander" on each pages. Note If the unit is turned off and the display disappears, it cannot be operated with the card remote commander unless (SOURCE) on the unit is pressed, or a disc is inserted to activate the unit first. The corresponding buttons on the rotary commander control the same functions as those on this unit. If your car has been parked in direct sunlight, allow the unit to cool off before operating it. ⷠPower aerial will extend automatically while the unit is operating. [. . . ] T Install the unit at an angle of less than 45° in a sturdy part of the car. The station does not broadcast any traffic announcements despite being TP. The following indications will flash for about 5 seconds, and an alarm sound will be heard. Connect a power aerial control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's aerial booster (only when your car has built-in FM/MW/LW aerial in the rear/side glass). [. . . ]