User manual SONY CDX R53300

[. . . ] 4-198-111-61(1) FM/MW/LW Compact Disc Player FM/MW/LW Compact Disc Player Operating Instructions Bedienungsanleitung Mode d’emploi Istruzioni per l’uso Gebruiksaanwijzing GB DE FR IT NL To cancel the demonstration (DEMO) display, see page 6. CDX-GT450U ©2010 Sony Corporation Be sure to install this unit in the dashboard of the car for safety. For installation and connections, see the supplied installation/ connections manual. Notice for customers: the following information is only applicable to equipment sold in countries applying EU Directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-0075 Japan. [. . . ] ) AUX VOL*3 (AUX Volume level) Adjusts the volume level for each connected auxiliary equipment: “+18 dB” – “0 dB” – “–8 dB. € This setting negates the need to adjust the volume level between sources. 2 Press the select button or (ZAP) when a track you want to listen is played back. The track that you select returns to normal play mode from the beginning. Tips • You can select the playback time from about 6 seconds/15 seconds/30 seconds (page 17). 14 Enjoying sophisticated sound functions — Advanced Sound Engine Advanced Sound Engine, Sony’s new sound engine, creates an ideal in-car sound field with digital signal processing. 1 Rotate the control dial to select the frequency range, then press it. Selecting the sound quality — EQ7 Preset You can select an equalizer curve from 7 equalizer curves (“XPLOD, ” “VOCAL, ” “EDGE, ” “CRUISE, ” “SPACE, ” “GRAVITY, ” “CUSTOM” or “OFF”). 0 kHz 2 Rotate the control dial to adjust the volume level, then press it. Rotate the control dial until “EQ7 PRESET” appears, then press it. Rotate the control dial until the desired equalizer curve appears, then press it. The equalizer curve is stored in “CUSTOM, ” and the display returns to normal reception/ play mode. Optimizing sound by Time Alignment — Listening Position The unit can change the localization of sound by delaying the sound output from each speaker to suit your position, and simulate a natural sound field with the feeling of being in the center of it wherever you sit in the car. Customizing the equalizer curve — EQ7 Setting “CUSTOM” of EQ7 allows you to make your own equalizer settings. Rotate the control dial until “EQ7 SETTING” appears, then press it. Rotate the control dial until “BASE” appears, then press it. €FRONT L” (1): Front left “FRONT R” (2): Front right “FRONT” (3): Center front “ALL” (4): In the center of your car “OFF”: No position set 4 You can also set the approximate subwoofer position from your listening position if: – the audio output is set to “SUB-OUT” (page 17). € continue to next page t 15 The options for “SET SW POS” are indicated below. €NEAR” (A): Near “NORMAL” (B): Normal “FAR” (C): Far Tip The DM+ setting can be memorized for each source. 1 2 3 4 Using rear speakers as subwoofer — Rear Bass Enhancer Rear Bass Enhancer enhances the bass sound by applying the low pass filter setting (page 17) to the rear speakers. This function allows the rear speakers to work as a subwoofer if one is not connected. Rotate the control dial until “SET POSITION” appears, then press it. [. . . ] T Connect a power antenna (aerial) control lead (blue) or accessory power supply lead (red) to the power supply lead of a car’s antenna (aerial) booster (only when your car has built-in FM/ MW/LW antenna (aerial) in the rear/side glass). T If the auto antenna (aerial) will not go up, check the connection of the power antenna (aerial) control lead. €PI SEEK” appears and the unit starts searching for another frequency with the same PI (Program Identification) data. € The disc has been forcibly inserted upside down or in the wrong way. [. . . ]