User manual SONY CDP-CX100

[. . . ] ⷠDo not place the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Refer to them whenever you call upon your Sony dealer regarding this product. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] When you connect via the DIGITAL OUT (OPTICAL) connector, noise may occur when you play CD software other than music, such as a CD-ROM. If you turn on the player with a CD in the tray You can start playing automatically from the beginning of the CD. If you connect a commercially available timer, you can start playing the CD at any time you want. Turn on the amplifier and select the CD player position so that you can listen to the sound from this player. You can adjust the output level with the LINE OUT LEVEL +/­ on the remote (CDP-CX100 only) Z The disc tray closes and the player plays all the tracks once (Continuous Play). You can adjust the headphones volume on the remote (CDP-CX100 only) Z Connect the headphones to the PHONES jack and adjust the volume with the LINE OUT LEVEL +/­ on the remote. Pause Resume play after pause Go to the next track Go back to the preceding track Stop play and remove the CD You can check information about the disc using the display. While playing a disc, the display shows the current track number, playing time and the music calendar. Checking the total number and playing time of the tracks press TIME before you start playing. The display shows the total number of tracks, total playing time and music calendar. The track numbers in the music calendar disappear after they are played. After one second The program remains even after the Program Play ends when you press · , you can play the same program again. To select a track with a number over 10 Notes ⷠThe total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. If you've made a mistake Press CLEAR, then press the correct track number. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. The program remains even after the Program Play ends When you press (, you can play the same program again. You can check the total playing time while programming using the remote (Program Edit) To select a track, press = or + and check the total playing time. The total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a program which already contains 24 tracks. Each time you press this button, the display shows the track number in the programmed order. After the last track in the program, the display shows "End" and returns to the original display. [. . . ] When you record on both sides of the tape, the player pauses at the end of the program for side A. The indication appears while checking the program for side A and while checking the program for side B. When tracks, which aren't numerically consecutive on the disc, are programmed consecutively (i. You can have the player create a program that will fit the length of the tape. [. . . ]