User manual SONY CDP-597

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The warranty shall be invalidated if used in commercial environments, such as by disc jockeys, etc. You are cautioned that any changes or modification not expressly approved in this manual could void your authority to operate this equipment. Refer to them whenever you call upon your Sony dealer regarding this product. [. . . ] Therefore, if you want to start ALL DISCS Shuffle Play again from the beginning, be sure to repeat the procedure from Step 1. All tracks of another disc(s) Other tracks on the same disc Other tracks on other discs The programs remain even after Program Play ends when you push the JOG dial or press · , you can play the same program again. When you press PLAY MODE to select Program Play during Continuous or Shuffle Play The program remains until you erase them Even if you replace discs, the programmed disc and track numbers remain. However, the disc and track numbers that are not found in the player or on the disc are deleted from the program, and the rest of the program is played in the programmed order. If you press the PLUS ONE button during Program Play, Program Play will be canceled (see page 19). When the disc has more than 10 tracks, press 0 first then press the corresponding number to enter a track number from 1 to 9. All tracks of another disc(s) Other tracks on the same disc Other tracks on other discs Hold down CLEAR until "CLEAR" appears in the display. When you insert a disc into the PLUS ONE slot, you can play the disc independently from other discs. The play mode you have selected (except for Program Play) remains active even if you use this function. Each time you press this button, the display shows the disc and track number of each step in the programmed order. (When a whole disc is programmed as one step, "ALL" appears instead of the track number. Turn the JOG dial to select the disc you want to assign a Disc Memo to, then push the JOG dial. If the disc slot you select does not have any disc, "NO DISC" appears in the display and you cannot assign a Disc Memo. Input the new Disc Memo following the procedure in "Labeling Discs" on pages 24 to 26. To control the second player directly using the supplied remote Set CD 1/2/3 on the remote to CD 3 which is the same position as the COMMAND MODE selector on the rear panel of the second player. The new Disc Memos are stored on this player's memory, so you cannot display them on the second CD player. Loading the Disc Memos of the second CD player If the second CD player has the Disc Memo function (see page 24), you can load the Disc Memos of the second CD player to this player's memory and display them on this player. Turn the JOG dial until "LOAD 2ND MEMO" appears in the display. You can manually fade the sound in or out to prevent tracks from starting or ending abruptly. Note that you cannot use this effect when you use the DIGITAL OUT (OPTICAL) connector. When you connect the second player, you can play tracks in this player and those in the second player alternately in any play mode (see "Connecting Another CD Player" on page 6). select one of the following methods: · No-Delay Play: The current player changes at each track. [. . . ] Caution -- The use of optical instruments with this product will increase eye hazard. Should any solid object or liquid fall into the cabinet, unplug the player and have it checked by qualified personnel before operating it any further. When transporting the player, open the front cover then remove all the discs from the player and turn the power off. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. [. . . ]