User manual SONY CDP-990 DIMENSIONS DIAGRAM

[. . . ] You can at any time fine-tune the settings on-screen to more closely match your particular listening space. In this case, making the settings from your chair has the added advantage of listening to the effects while you adjust the settings. All you need to do is follow two steps using on-screen operation: (1) select the size of your theater room, from Small, Medium, or Large, and (2) select the listening position, from Center or Rear. The Quick Set-up feature then automatically adjusts the soundfield to suit this environment. [. . . ] The Quick Set-up feature then automatically adjusts the soundfield to suit this environment. The video decoder uses a Super Sub Alias Filter that extends the video band into the high range while also suppressing noise from outside this band. This results in high picture quality playback with enhanced horizontal resolution and greater detail. s Auto Function Button When you stop a DVD movie or music program in the middle and have even turned off the CDP-990's power (leaving it in standby mode), pressing the Auto Function button on the remote controller lets you continue the program in the same playback mode from where it was stopped. s Dolby Digital and DTS Decoders Equipped with both Dolby Digital and DTS 5. 1 channel decoding, the CDP-990 provides thrilling surround sound with the thousands of Dolby Digital and DTS encoded DVDs, as well as the growing library of DTS 5. 1 channel music recordings available on CD. s Dolby Pro Logic II Decoder · Enjoy any 2-channel source in stunning 5. 1-channel surround playback. The Dolby's newly developed Pro Logic II decoder reproduces dynamic 5. 1-channel surround sound from any 2-channel source: DVD, VHS, satellite and television broadcasts, radio, and CDs. Dolby Pro Logic II uses matrix decoding technology that has been dramatically improved over Pro Logic. With Pro Logic II, for instance, the Surround (Rear) channels are in stereo (only mono with Pro Logic) and playback covers the full frequency range (only up to 7 kHz with Pro Logic). These improvements let you enjoy a wide variety of 2-channel sources with the exciting effects of 5. 1-channel surround sound. 2-ch stereo playback 5-ch surround playback When simulating 5. 1-channel surround from 2-channel sources, the sound that Dolby Pro Logic output through the Surround speakers was only a monaural synthesis of the two stereo channels (left diagram). With Pro Logic II, however, the output from the Surround speakers is in stereo, giving you an enhanced sense of space (right diagram). s Personal Memory Plus The CDP-990's Personal Memory Plus function allows you to store the parameter of the surround mode for further sound source customization. Extension wire, AL speaker base for center speaker DSW-60, Subwoofer Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . W/feet : 10. 5" (W) x 13. 2" (H) x 15. 7" (D) W/out feet : 8. 5" (W) x 11. 8" (H) x 15. 7" (D) Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Extension wire *Design and specifications are subject to change without notice. *"Dolby", "Dolby Digital", "Pro Logic II" and the double-D device are registered trademarks of Dolby Laboratories Licensing Corporation. *DTS" and "DTS-ES Extended Surround" are trademarks of Digital Theater System, Inc. Specifications CDP-990, DVD Surround Receiver s DVD Section Signal system . . . . . . . . . . . . . . . . . . . . DVD Video, Video CD, Music CD, CD-R/RW (audio/MP3) Video output level/Load impedance Composite output . . . . . . . . . . . . . . Y; 1. 0 Vp-p (with 75 ohms load), C; 0. 286 Vp-p (with 75 ohms load) Component Video Output . . Y; 1. 0 Vp-p (with 75 ohms load), Pb / Cb; 0. 648 Vp-p (with 75 ohms load), Pr / Cr; 0. 648 Vp-p (with 75 ohms load) Audio output level/Load impedance Audio output . . . . . . . . . . . . . . . . . . . . . . 2 V (CDR/TAPE)(1 kHz, 0 dB: DVD) s Power Amplifier Section Rated output Front . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 W + 43 W (6 ohms, 1 kHz, 0. 9 % THD) Center. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Y; 1. 0 Vp-p (with 75 ohms load), Pb / Cb; 0. 648 Vp-p (with 75 ohms load), Pr / Cr; 0. 648 Vp-p (with 75 ohms load) Audio output level/Load impedance Audio output . . . . . . . . . . . . . . . . . . . . . . 2 V (CDR/TAPE)(1 kHz, 0 dB: DVD) s Power Amplifier Section Rated output Front . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 W + 43 W (6 ohms, 1 kHz, 0. 9 % THD) Center. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 W + 45 W (6 ohms, 1 kHz, 0. 9 % THD) Subwoofer . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]