User manual SIMA SCC-2

[. . . ] If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * Re-orient the receiving antenna * Relocate this equipment with respect to the receiver * Move this equipment away from the receiver. * Plug this equipment into a different outlet so that this equipment and receiver are on different branch circuits. If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. [. . . ] Has correct mode (AV, Line, Tuner, etc. ) been set on the VCR or DVD Correct connecting cable?Have the RCA cables been mixed up at the input and output of the VCR/DVD? Congratulations on your purchase of Sima's GoDVD!- Model CT-2, (1) RCA style Video Cable (1) 7. 5V, 500 mA AC adapter and This Instruction Manual Connection: GoDVD!should be connected between your playback VCR, DVD or camcorder and the recording VCR or DVD as shown below. Note: Regardless of which input is used, both outputs continuously deliver an output signal. The unit will automatically detect whether the video input is in NTSC (USA) or PAL (Europe) format. The output format is determined by the setting of the PAL/NTSC output switch. · Is the connecting cable of the plug-in adapter damaged? Picture rolling · TV does not support 50/60 Hz scan rates. GoDVD!Allow you to play a PAL DVD or video tape on an NTSC TV that supports only 60 Hz scan. Allow you to copy an NTSC DVD or video tape to an NTSC DVD recorder or VCR in the PAL format to send over seas, unless the recorder supports both formats. Only the video cables are to be connected to GoDVD!. Audio cables should be connected directly between the playback and recording units. With Hi-8 or SVHS capability, connect your S-video cables to GoDVD!. Operation 1. Select the PAL/NTSC output format by setting the PAL/NTSC output switch to the desired setting. Note: The unit will automatically detect whether the input is PAL or NTSC, however you must select the desired output format. [. . . ] The LED indicator light shows which Input format and Enhancement mode are selected. For example, a steady green light means you have selected a composite input signal and will output in the Normal video mode. An orange blinking light indicates an S-video input signal with one of three enhancement modes. [. . . ]