Detailed instructions for use are in the User's Guide.
[. . . ] Product Manual
Cheetah 15K. 6 SAS
ST3450856SS ST3300656SS ST3146356SS
100466193 Rev. A October 2007
©2007, Seagate Technology LLC All rights reserved. A October 2007 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Cheetah, SeaTools and SeaTDD are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/ or other countries. [. . . ] This specification assumes that the drive is packaged in the shipping container designed by Seagate for use with drive.
HDA Temp. Check Point
1. 0
"
. 5"
Figure 8.
Location of the HDA temperature check point
32
Cheetah 15K. 6 SAS Product Manual, Rev. A
6. 4. 2
Relative humidity
The values below assume that no condensation on the drive occurs. Operating 5% to 95% non-condensing relative humidity with a maximum gradient of 20% per hour. Non-operating 1, 000 to +40, 000 feet (305 to +12, 210 meters) 6. 4. 4 Shock and vibration
Shock and vibration limits specified in this document are measured directly on the drive chassis. If the drive is installed in an enclosure to which the stated shock and/or vibration criteria is applied, resonances may occur internally to the enclosure resulting in drive movement in excess of the stated limits. If this situation is apparent, it may be necessary to modify the enclosure to minimize drive movement. The limits of shock and vibration defined within this document are specified with the drive mounted by any of the four methods shown in Figure 9, and in accordance with the restrictions of Section 8. 3. Operating--normal The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not exceeding 15 Gs at a maximum duration of 11 msec (half sinewave). The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not exceeding 25 Gs at a maximum duration of 2 msec (half sinewave). Operating--abnormal Equipment, as installed for normal operation, does not incur physical damage while subjected to intermittent shock not exceeding 40 Gs at a maximum duration of 11 msec (half sinewave). Shock occurring at abnormal levels may promote degraded operational performance during the abnormal shock period. Specified operational performance will continue when normal operating shock levels resume. Non-operating The limits of non-operating shock shall apply to all conditions of handling and transportation. The drive subjected to nonrepetitive shock not exceeding 80 Gs at a maximum duration of 11 msec (half sinewave) shall not exhibit device damage or performance degradation. The drive subjected to nonrepetitive shock not exceeding 300 Gs at a maximum duration of 2 msec (half sinewave) does not exhibit device damage or performance degradation. The drive subjected to nonrepetitive shock not exceeding 150 Gs at a maximum duration of 0. 5 msec (half sinewave) does not exhibit device damage or performance degradation. Shock may be applied in the X, Y, or Z axis.
Cheetah 15K. 6 SAS Product Manual, Rev. Packaged disk drives shipped as loose load (not palletized) general freight will be packaged to withstand drops from heights as defined in the table below. For additional details refer to Seagate specifications 30190-001 (under 100 lbs/45 kg) or 30191-001 (over 100 lbs/45 Kg).
Package size Packaged/product weight Drop height
<600 cu in (<9, 800 cu cm) 600-1800 cu in (9, 800-19, 700 cu cm) >1800 cu in (>19, 700 cu cm) >600 cu in (>9, 800 cu cm)
Any 0-20 lb (0 to 9. 1 kg) 0-20 lb (0 to 9. 1 kg) 20-40 lb (9. 1 to 18. 1 kg)
60 in (1524 mm) 48 in (1219 mm) 42 in (1067 mm) 36 in (914 mm)
Drives packaged in single or multipacks with a gross weight of 20 pounds (8. 95 kg) or less by Seagate for general freight shipment shall withstand a drop test from 48 inches (1, 070 mm) against a concrete floor or equivalent.
Z Y X Z
X Y
Figure 9.
Recommended mounting
34
Cheetah 15K. 6 SAS Product Manual, Rev. Operating--normal The drive as installed for normal operation, shall comply with the complete specified performance while subjected to continuous vibration not exceeding 10500 Hz @ 0. 5 G (zero to peak) Vibration may be applied in the X, Y, or Z axis. Operating--abnormal Equipment as installed for normal operation shall not incur physical damage while subjected to periodic vibration not exceeding: 15 minutes of duration at major resonant frequency 10500 Hz @ 0. 75 G (X, Y, or Z axis) Vibration occurring at these levels may degrade operational performance during the abnormal vibration period. [. . . ] Worldwide support is available 24 hours daily by email for your questions. Presales Support: Presales@Seagate. com Technical Support: DiscSupport@Seagate. com Warranty Support: http://www. seagate. com/support/service/index. html mySeagate my. seagate. com is the industry's first Web portal designed specifically for OEMs and distributors. It provides self-service access to critical applications, personalized content and the tools that allow our partners to manage their Seagate account functions. Submit pricing requests, orders and returns through a single, password-protected Web interface-anytime, anywhere in the world. [. . . ]