User manual SANUS VISIONMOUNT SIDE SPEAKER MOUNT-XAS1A

[. . . ] XAS1A (6901-100148 <01>) Thank you for choosing the Sanus Systems XAS1A. The XAS1A is designed to mount speakers on each side of a VMDD26 VisionMount full motion TV mount. [. . . ] When completed, refer back to this Instruction manual, starting at Step 3: Install Extension Tubes. 1- 2: Existing Installations NOTE All graphics in this section are generic and are only used to illustrate a procedure. [25] Disconnect all electrical connections and release all cables from any cable tie downs. Remove the safety bolt [a] as shown. [a] Lift the TV and arm assembly [B] off the wall plate [C] as shown Lean the assembly against a wall or other vertical surface. [B] HEAVY!You will need assistance with this step. [C] [D] [F] Using an Allen Key, loosen the eight vise assemblies [D]. Remove the lower cross tube [E]; then, remove the upper cross tube [F] as shown. [E] [D] 6901-100148 <01> 2: Cross Tube Installation [25] [02] [J] [G] [02] [H] Slide the cross tubes [02] into the first monitor bracket [g], through the arm assembly [H] and then through the second monitor bracket [J]. Using the Allen Key, tighten the six vise assemblies until the cross tubes no longer rotate. Attach the TV and arm assembly to the wall plate according to the instructions provided with the VMDD26 Full Motion Mount. You will need assistance with this step. NOTE If you no longer have your VMDD26 Installation Manual, download one from www. Sanus. com or call Sanus Systems Customer Service. 3: Install Extension Tubes [02] Slide the four extension tubes [03] (felt end first) into the cross tubes [02]. [03] [03] [03] [03] [02] 6901-100148 <01> 4: Install Threaded Tube Clamp & Clamp Knob Slide the threaded tube clamps [05] onto the extension tubes [03], aligning the notches in the threaded tube clamp and cross tubes [02]. [02] [06] [05] [03] [02] [03] [05] [06] 5: Secure Vise assemblies to Brackets [04] [07] [22] [01] 4x NOTE Do not overtighten the nut [22]. The vise assembly [04] must rotate freely around the carriage bolt [07]. 6901-100148 <01> 6: attach Speaker Brackets [25] Slide the speaker brackets [01] into the extension tubes [03]. Use the Allen key to tighten the four vise assemblies [04] until the speaker brackets do not slide on the extension tubes. NOTE Maximum extension of the cross tubes is 162 cm (64 in. ). Do not exceed the maximum extension. [03] [01] [04] [03] 6901-100148 <01> 7: attach Speakers 7 - 1: attach Speakers using Threaded Fasteners [03] [03] [08] - [13] Determine the thread of the fastener required by threading each size fastener into the back of the speaker. If using M4 fasteners, [12] or [13], be sure to install the lock washer [20]. The speaker wires may be routed to the speaker terminals through the extension tubes [03]. [. . . ] CSAV makes no representation of warranty, expressed or implied, regarding the information contained herein. CSAV assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. 6901-100148 <01> [. . . ]