User manual SANUS VISIONMOUNT LCD DESK MOUNT-SD103
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SANUS VISIONMOUNT LCD DESK MOUNT-SD103. We hope that this SANUS VISIONMOUNT LCD DESK MOUNT-SD103 user guide will be useful to you.
Manual abstract: user guide SANUS VISIONMOUNT LCD DESK MOUNT-SD103
Detailed instructions for use are in the User's Guide.
[. . . ] Replacement parts for products purchased through authorized dealers will be shipped directly to you. Check carefully to make sure that there are no missing or defective parts. [. . . ] check that the pad is resting flat on the finished surface of the desk. Secure the pillar by tightening the clamp until the base rests firmly against the bottom of the desk. To attach the Pillar through a wire management hole as shown in Figure 2b, you must first separate the inner and outer stems on the Pillar. Loosen and remove the two screws on the stem with the Allen Key [D] as shown in Figure 1 above, and slide the stems apart. Place the Pillar through the wire management hole, resting the pad flat on the finished surface of the desk. Then secure the pillar by tightening the clamp until the base rests firmly against the bottom of the desk. Step 3: Attach the Monitor Mount to a Monitor with a Flat Back NOTE: For monitors with curved backs or obstructions, go to Step 4. Attach the Monitor Mount [B] to the back of your LCD monitor using the M4 x 10 mm Screws [E], as shown in Figure 3. Position the Monitor Mount so that the large side of the tapered hole faces the bottom of the monitor. Place the four screws through the Monitor Mount into the VESA bolt mounting pattern on the back of the monitor. Step 4: Attach the Monitor Mount to a Monitor with a Curved Back or Obstructions Attach the Monitor Mount [B] to the back of your LCD monitor using the M4 x 30 mm Screws [F] and the Spacers [G], as shown in Figure 4. Position the Monitor Mount so that the large side of the tapered hole faces the bottom of the monitor. [. . . ] Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SANUS VISIONMOUNT LCD DESK MOUNT-SD103
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SANUS VISIONMOUNT LCD DESK MOUNT-SD103 will begin.