User manual SANUS VISIONMOUNT 8QUOT LONGER CENTER PLATE FOR VMPL3-VMXA1

[. . . ] Assembly Instructions for Model: VMXA1 Thank you for choosing a Sanus Systems VisionMountTM Model: VMXA1. [. . . ] Determine how wide you want the Wall Plate Assembly based on the following criteria: · Width of television (Wall Plate Assembly should be configured so the total width is less than the overall width of your television) · Width of Hole Pattern on television (Wall Plate Assembly should be wider than the horizontal distance between threaded inserts on the back of your TV by at least 2 [50. 8 mm]) · Stud Spacing (Sanus recommends attaching Wall Plate Assembly to three studs for televisions over 125 lbs. [56. 7 Kg]) To adjust the width of the Wall Plate Assembly (A) using the VMXA1: Remove each Flange Nut and Nylon Washer from the Wall Plate Assembly (A) as shown in Diagram 1A. Diagram 1A Nylon Washer Wall Plate Assembly (A) Flange Nut Remove the Center Plate of the Wall Plate Assembly (A) as shown in Diagram 1B. Diagram 1B Center Plate Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 08. 02. 06 (100042) Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Separate the Left and Right Extension of the Wall Plate Assembly (A) and set them to so that their outer edges are equal to the desired width. NOTE: All four of the Threaded Studs must pass through the VMXA1 for the installation to be safe. [. . . ] Diagram 1D Right Extension Left Extension VMXA1 Flange Nut Nylon Washer Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 08. 2. 06 (100042) Customer Service: 800. 359. 5520. [. . . ]