User manual SANUS PLATINUM FURNITURE FLAT PANEL TV STAND-PFFP2

[. . . ] Check carefully to make sure none of the parts are missing or defective. Replacement parts for products purchased from an authorized dealer will be shipped directly to you. Please call Sanus Systems before returning products to the retail store where you purchased them. [. . . ] Step 4: Add Shelf Bracket to Pillar Add the Shelf Bracket Assembly to the Pillar (g) by sliding it down from the top to the desired position on the Pillar. Once you have the Shelf Bracket Assembly in place, proceed to tighten the M8 Allen Bolts (r) with an Allen Key (oo) so the Shelf Bracket Assembly is firmly in place. Step 5: Add Wall Bracket Slide the Wall Bracket Assembly down into place on the Pillar (g). Make sure the Wall Plate (h) fits into the channel in the Pillar as seen in the Top View of Diagram 5. Once the Wall Bracket Assembly is in the desired position, tighten the M8 Allen Bolts (r) with an Allen Key (oo) so the Wall Bracket Assembly is attached to the Pillar. Attach the Wall Bracket Spacers (i) to the Wall Bracket (b) by sliding the Wall Bracket Spacers from the side so the plastic tabs into the correct oval holes on the Wall Bracket. You may have to loosen the M8 Bolts in the Wall Bracket to have enough space to fit the Wall Bracket Spacers in between the Wall Bracket and the Pillar. Step 6: Add the Glass Shelves Take the Glass Shelf Washer (l) and insert it onto the Glass Shelf (c, d). Make sure the holes in the Glass Shelf Washer and the Glass Shelf are aligned. Thread each 1/4-20 Allen Bolt (s) down through a Plastic Washer (w), the Glass Shelf and into the Shelf Bracket assembly. Next, add the Top Cap (n) to the top of the Pillar (g) by lining up the two plastic dowels on the bottom of the Top Cap with the corresponding pattern on the top of the Pillar as seen in Detailed View B of Diagram 6. Step 7: Mounting Monitor Brackets to a television with a flat back First, determine the diameter of the Bolt (y, z, aa, bb) your TV requires by hand threading them into the threaded insert on the back of the TV. Once you have determined the correct diameter, see the appropriate Diagram below. You will thread the Bolt through the appropriate Lock Washer (gg, hh, ii, jj), a Washer (kk, ll), the Monitor Bracket (e, f), and finally into the TV. Make sure the Monitor Brackets are vertically centered and level with each other. Note: For televisions with a curved back, or an obstruction near the threaded insert see Step 8. [. . . ] Étape 5 : Ajout du support de fixation Glissez l'assemblage du support de fixation jusqu'à sa place spécifique sur la colonne (g). Fixez les entretoises du support de fixation (i) au support de fixation (b) en faisant glisser les entretoises du support de fixation sur le côté pour que les capuchons en plastique soient insérés dans les trous ovales correspondants sur le support de fixation. Il se peut que vous ayez à desserrer les boulons M8 dans le support de fixation pour avoir assez d'espace pour insérer les entretoises du support de fixation entre le support de fixation et la colonne. [. . . ]