User manual SANUS MINI SYSTEM MAPLESILVER STAND-AFM2 II

[. . . ] Assembly Instructions for Model: AFM2 II Thank you for choosing the Sanus Systems Model AFM2 II. [. . . ] Lay the Equipment Platform face down on a soft surface with the threaded inserts facing up and the square edge facing away from you. Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1. 20. 06 (100001) Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Step 1 - Attach the Short pillars to the Equipment Platform NOTE: The Short Studs have a long and short end. Thread the short end of the Short Studs (D) into the inserts in the Equipment Platform (I) until snug. Thread a Short Pillar (A) onto each Short Stud (D) and firmly hand tighten. Diagram 1 A D I Step 2 - Attach the Plastic CD Holder to the Equipment Platform Locate the small pilot holes in the Equipment platform (I); then, using the two Small Screws (C), attach the Plastic CD Holder (G) to the Equipment Platform. Diagram 2 C G Front Edge Slot I noteNOTE: Slots in the Plastic CD Holder (G) must face toward front or rounded edge of the Equipment Platform (I). Step 3 - Attach the Speaker Platform Thread a Long Stud (E) four turns into the open end of each Short Pillar (A); then place the Speaker Platform (H) over the Short Pillars and Long Studs, making sure the beveled edge or the Speaker Platform faces the same way as the beveled edge of the Equipment Platform (I). [. . . ] Diagram 5 F B Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1. 20. 06 (100001) Customer Service: 800. 359. 5520. [. . . ]