User manual SAMSUNG WT11J7

[. . . ] 3 CLEANING THE MACHINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 WASHING PROCEDURE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 TO WASH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SPIN DRY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For washing machines with ventilation openings in the base, that a carpet must not obstruct the openings. PRECAUTIONS WHEN OPERATING Don't use excessively hot water. If nails or pins remain in pockets, they may damage the washer or clothes. Never splash water on the control panel. (WITH PUMP) Be sure to cover with the safety cover on laundry before spinning. Be sure lay the drain hose(A) down. (WITHOUT PUMP) Be sure place the drain hose(A) in sink or bath about 70~80cm above the ground. 1 DC68-01941C_IB_ENG_T12J. indd 2 4/27/2006 9:09:23 AM DESCRIPTION OF PARTS When you open this lid while the spin basket is spinning, the spinning will be stopped by brake system. SPIN DRYER LID INNER LID DRAIN HOSE (WITH PUMP) OVER FLOW FILTER LINT FILTER SPIN DRYER BASKET SPIN DRYER HATCH This is used for gathering the dregs which are made during washing. WASH TUB POWER CORD Be sure to keep the lid closed during washing and spinning. WASH TUB LID The plug's shape may not correspond with this drawing. EARTH WIRE SWT90B1(P) (Option) (WITHOUT PUMP) WATER DRAIN HOSE PULSATOR DRAIN FILTER (WITH PUMP) CONTROL PANEL 1. WATER SELECTOR During washing, WATER SELECTOR KNOB should be selected to wash. During spin rinsing, WATER SELECTOR KNOB should be selected to spin. AIR TURBO SPIN TIMER This is used to set the spin time, 1-10 minutes. 1 2 3 4 5 2 DC68-01941C_IB_ENG_T12J. indd 3 4/27/2006 9:09:26 AM INSTALLATION ENVIRONMENT Leave some space Space at last 15cm between the washer and the wall. If the washer is placed on an uneven or weak surface, noise or vibration may be occured. Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers, etc. Remove dirts and rotate the filter clockwise until it locks in position. CONNECTING THE DRAIN HOSE Insert the drain hose(a) and push it tighly to be connected as arrow direction. (WITHOUT PUMP) Install the drain hose(A) about 70~80cm above the ground for pump model. . CLEANING THE MACHINE CLEANING THE LINT FILTER If the dregs are filled up in the lint filter after finishing the wash, push down(1) and pull it out(2) as shown in figure. Remove the collected lint and rinse the filter net. OVERFLOW FILTER Pull the upper side of the overflow filter with two fingers into the hole `A' in the direction of arrow as shown in the figure. CLEANING THE COVER WINDOW SPIN 1. Insert the cover window spin back and rotate it counterclockwise until locks in positon. Remark : Should be cleaned the cover window spin at least 1 time a month. CLEANING THE WASH TUB Wipe off strains on the cabinet and operation panel with soft cloth. Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. 3 DC68-01941C_IB_ENG_T12J. indd 4 4/27/2006 9:09:28 AM WASHING PROCEDURE TO WASH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. Before starting washing, check the following; · Connect the water supply hose and open the water tap. Fill water in the wash tub and add the detergent. (WITHOUT PUMP) · Place the drain hose(A) in sink or bath about 70~80cm above the ground. (WITH PUMP) 2. SOAK · Set the WASH TIMER to the point more than "15" for SOAK function. [. . . ] - Be sure place the drain hose in sink or bath. (Without pump) (With pump) 2. Supply the proper amount of water as not to overflow the top of the washing tub. OVER FLOW RINSE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. Keep suppling water Adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. 3. As soon as the WASH TIMER shuts off, turn off the water tap. (Without pump) 2. Set the CYCLE SELECTOR KNOB to `DRAIN'. 5 DC68-01941C_IB_ENG_T12J. indd 6 4/27/2006 9:09:35 AM ADDITIONAL RINSE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . After rinsing you can select this course for more effective rinse (Don't select only this course for rinse. ) Load the laundry evenly into the spin basket. 1 2 3 4 (b) After stopping water supply, cover the laundry with safety cover and close the inner lid. Set the WATER SELECTOR KNOB to SPIN(a) and CYCLE SELECTOR KNOB to (a) `DRAIN'. (b) Supply water for about 1minute. [. . . ]