User manual SAMSUNG FINO 20SE

[. . . ] Remove the battery from the camera when the camera is not used for an extended period. The indicator will disappear on the LCD panel when the power is turned off. Be sure to check the date and shooting mode when you load a new battery. If the date or time is incorrect, please refer to page 19 and adjust accordingly. [. . . ] Both elbows (horizontal picture) or one elbow (vertical picture) should be held close to your body. Ensure you can see all four sides of the viewing frame when composing your shot. Avoid obstructing the lens when you take a picture. Pictures can be spoiled when a finger, hair or camera strap falls in front of the Lens, Exposure Sensor or Auto-focus Windows. When you take vertical pictures with flash, the flash should be above the lens. 14 TAKING PICTURES Aim the Autofocus frame at a subject. (Refer to page 8) Press the Shutter button half way down. The film will automatically advance after shooting and the frame counter will advance. Exposure range (WIDE) : 1. 0m ~ (TELE) : 1. 2m ~ NOTE When the flash is being charged, the indicator(Green LED) will be blinked rapidly. In order to avoid camera shake, hold the camera steadily and press the Shutter button gently, particularly when using longer focal lengths (Tele). The quality of pictures is not guaranteed when the distance is less than 1. 0m (WIDE) or 1. 2m (TELE). Pressing the shutter button will activate the zoom lens for accurate focusing. But there is no change of focal length. 15 BUZZER OPERATION The buzzer function can be selected by Buzzer ON/OFF button and it will operate only if the buzzer mark appears on the LCD panel. According to the function, the buzzer sound is as follows. Buzzer sound Peek long beeps(4Hz) long beeps(2Hz) Function Selection Warning Warning Application When you press Flash, Buzzer button When Mode Dial is changed When hand shake is detected When a film is loaded incorrectly When the rewinding is completely finished NOTE The buzzer function set automatically when the power is turned on after inserting new battery. 16 USING THE FOCUS LOCK If you want to focus on a subject that is not in the centre of your picture, use the Focus Lock function described below. The Flash Mode Order is subject to change without prior notice. <Auto red-eye reduction> <Auto flash> <Fill-in flash> <Flash off> NOTE In case of the "Auto Flash" function, the camera will retain the mode even though the camera is turned off. (but)When you change the battery, the mode will be set to Auto red-eye reduction. 21 AUTO AUTO RED-EYE REDUCTION In low light conditions, the flash will automatically fire to obtain a suitable exposure. You can decrease the red-eye phenomenon automatically when taking a portrait picture in low light. <Auto flash> <With Auto red-eye reduction> NOTE When you press the shutter button down, the Red-eye reduction lamp will operate and the flash will fire. 22 AUTO AUTO FLASH Select the Auto Mode by pressing the FLASH button 1 time. Auto flash mode activates the flash by measuring the brightness of the object. Flash will not engage when the shooting object is too bright. NOTE Once the Auto Flash Mode is selected, it will remain active even when it is turned off. (but)When you change the battery, the mode will be set to Auto red-eye reduction. 23 FILL-IN FLASH Select this mode by pressing the FLASH button 2 times. Your camera contains high voltage circuitry and may cause injury if interfered with. The temperature range in which the camera operates is between 50 and -10 (122 ~14 ). The camera performance may be impaired when used in very cold weather. If you plan to take pictures when the temperature is below 7 (45 ), take care to keep your camera and battery warm between shots. If your camera becomes very cold, allow it to return to room temperature slowly by keeping it in its case. [. . . ] Dark light will cause them to open wide; bright light will cause the narrowing of the irises. - If the irises were opened before pressing the shutter or cannot be opened, the irises are not operating properly. Film transferring device - It is normal to hear the motor running after you open and close the camera cover. - It is normal to hear the motor running after you press the Mid-roll rewinding button. [. . . ]