User manual SAECO D.A. COMBISNACK
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SAECO D.A. COMBISNACK. We hope that this SAECO D.A. COMBISNACK user guide will be useful to you.
Manual abstract: user guide SAECO D.A. COMBISNACK
Detailed instructions for use are in the User's Guide.
[. . . ] Vending machine
ACCESSORIES AND PAYMENT SYSTEMS
D. A.
COMBISNACK
Type: D. A. COMBISNACK
Espresso Italia PTY LTD www. espressoitalia. com. au Freecall 1300 660 976
USE AND MAINTENANCE
English
Contents
123456789DIAGRAM OF CONNECTIONS TO THE KEYPAD BOARD/CPU:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 24 -
Espresso Close the vending machine lower door. Italia
PTY LTD www. espressoitalia. com. au 9 Freecall 1300 660 976
English
5-
FLOAT KIT
-
It allows the display to read the discharge fluid maximum level. In this condition, no hot beverage is available and the display will read "ERROR 09". The float can be installed in different positions according to whether the machine is connected to a water network (22 L tank) or uses an independent tank (7L tank).
Slide the other end of the reed wiring inside the hole (ref. 1 basket set for discharge fluid level 2 screws 1 reed wiring -
fig. The drain level control system doesn't work if two sensors are connected.
If it is applied to the water network version, it is necessary to remove the 22L tank (ref. If it is applied on the independent tank version, it is necessary to remove the 7 L tank (ref. If no password has been assigned you enter the programming menu directly. Important If vending machine was assigned a password to enable the programming menu, "PASSWORD 0000" will appear on display with a flashing cursor on the first digit.
The vending machine can be fitted with an electromechanical pulse counter (24V DC) which will count the number of coffees or the total beverages brewed by the machine.
Assembly kit (fig. 35
Installation
Open the upper door and fasten the pulse counter (ref. 35).
To exit the programming menu and return to the normal operation of the vending machine: - press key 1 again; - remove the key from the safety switch to turn off the vending machine; - close the door and wait for the self-configuration process to end.
SISTEM MANAGEMENT
VM CODE 0000
STOP
MIN. 36 Couple the pulse counter wiring with the "CN14" connector of the board (fig. TEMPERATURE 108
Entries selectable only with complete menus
COLD TEMPERATURE 6
COMPRESSOR YES
DRAINAGE TANK NO
MECH. 38 Espresso Italia PTY LTD www. espressoitalia. com. au Freecall 1300 660 976
English
7-
WATER SOLENOID VALVE KIT
-
Open the upper door and loosen the screw (fig. 42) fixing the block support plate.
It is possible to brew hot water alone by installing the required kit
Assembly kit (fig. 40) by untightening the screws and disconnecting the ground wiring placed on the machine.
fig. 41) and hold the latter to avoid any excessive stress to the block support plate. 41
Espresso Italia PTY LTD www. espressoitalia. com. au 13 Freecall 1300 660 976
English
-
Screw the nut and fix the OR (ref. Remove the block support from its seat and screw the solenoid valve in the hole (fig. The solenoid valve must be placed with fastons upwards Reinstall the block support in their seat and tighten the screws.
-
Insert the pipe clamp (ref. 48) at the solenoid valve outlet and position the pipe retaining spring. Slide the other end of the pipe inside the assembly plate passage hole (ref. 46) that fastens the two unused cables.
-
Fasten the pipe end with fitting to the spout (fig. [. . . ] It is advisable to carry out all the electrical connections while the V. M. 90
-
Reassemble the rear panel and close the upper front door.
Espresso Italia PTY LTD www. espressoitalia. com. au 23 Freecall 1300 660 976
English
13 - SAECO WATER SOFTENER SUPPORT
This support allows fixing the water softener supplied by Saeco in a proper way.
-
Insert the water softener (ref. 92
Installation
Remove the machine rear panel and assemble the water softener support (ref. 93
24
Espresso Italia PTY LTD www. espressoitalia. com. au Freecall 1300 660 976
English
14 - PROGRAMMING KEY
The programming key allows the set data transfer in the following programming menu entries: PRICE MANAGEMENT. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SAECO D.A. COMBISNACK
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SAECO D.A. COMBISNACK will begin.