User manual ROSIERES LHP 812

[. . . ] This partition must be at least 10 mm from the underside of the cook top tray. Fixing the cook top to the unit The cook top is fixed to the unit by means of the brackets and accessories provided. Holes are provided in the bottom of the tray where the tabs (A) are inserted so that you can attach the screws (C) that hold the brackets (B) in place. A = tab for inserting in the bottom of the cook top tray B = fixing bracket C = screw Important - The figure below shows how the seal must be attached all around the perimeter. [. . . ] Coupling two or more Domino cook tops Cut out the work top to allow for the flush mounting of two or more Domino cook tops. First of all, place the steel supporting element (E) provided in the package in position, then insert the cook top (G) as illustrated in the figure below. Together with the seal on the two Domino cook tops, the steel support will ensure that the top is watertight. The Domino cook tops are fixed to the work top using the kit of brackets provided. Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated mains voltage and power available are suitable for its operation. The manufacturer will accept no liability for any personal injury or damage to property deriving from failure to comply with this requirement. For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord. If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of at least 3 mm between the cook top and the mains. To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the contacts inside. Do not drop hard objects on the glass surfaces as under some conditions they are sensitive to mechanical loads. If the glass-ceramic surface is accidentally broken or cracked, switch the appliance off immediately and contact the Customer Service Department. Ensure that cables and plugs of other domestic appliances inserted in sockets positioned near the barbecue do not come into direct contact with hot cooking surfaces. Do not, under any circumstances, clean the surface using steam cleaning appliances or similar. Even very small residues of food left on the surface will burn the next time the appliance is used. The stainless steel components of the appliance must be cleaned using non-abrasive, non-corrosive products. Do not use oven-cleaning products to clean the appliance as they are corrosive. Surface dirt can be removed using either a damp cloth or hot sodium carbonate. Remove residues of detergents using cold water, and carefully dry surfaces. [. . . ] Surface dirt can be removed using either a damp cloth or hot sodium carbonate. Remove residues of detergents using cold water, and carefully dry surfaces. Any remaining water stains which do not disappear using boiling water can be removed using vinegar or lemon, or lime-scale remover. Clean the frame or stainless steel container immediately using a wet cloth if they come into direct contact with one of these acid detergents. [. . . ]