Detailed instructions for use are in the User's Guide.
[. . . ] Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water. If any of these things happen, return the appliance to an authorized service center for examination and repair. Never drop or insert any object into any of the appliance's openings. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. [. . . ] Take the charging base that came with the shaver, and plug its cord into an electrical outlet. The shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. To preserve the life of the batteries, let them fully run out every six months, then recharge them for a full 24 hours. This allows the shaver to work the way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so only one screen touches the skin at a time. Make sure the shaver and your hands are dry when placing the shaver in the charging stand. When inserting the shaver into the charging stand, avoiding pushing on the screens, or they may become damaged. All Smooth & Silky® shavers give you a great, close shave wet or dry. Your Smooth & Silky® shaver is fully submersible in water, so you can shave with foam or soapy lather, in the shower or the tub. Dry use is great for a quick, close shave when you're in a hurry; no special preparation is necessary. After shaving, wet or dry, simply run the shaver under cold water to clean it. All Smooth & Silky® shavers are equipped with a trimmer that works with the foils to give you an extra close and comfortable shave. When trimming longer hairs, tip the shaver slightly so the trimmer glides across the skin. Remington recommends cleaning your shaver after every use for optimal performance. Instead, blow the shavings out or rinse the screens under cold or warm water. Cutters and trimmerUse the cleaning brush to sweep any loose hairs from the cutters and trimmers, or rinse/dunk them in cold or warm water. After cleaning, return the foils and head assembly to their original position on the shaver. If the shaver was rinsed with water, or if you used it in the shower, hold it facing downward into the sink, and turn it on for a few seconds to dispel additional water. The cutters and screens of your shaver will wear with use and eventually require replacement to maintain a close, comfortable shave. It is very important to replace your screens and cutters when necessary to ensure a close, comfortable shave without irritation. Depending on your shaving technique and habits, the screens will usually last 6 months; the cutters, 12 months. If you are replacing the cutters it's a good idea to replace the screens at the same time. [. . . ] , Attention: Consumer Services , 601 Rayovac Drive , Madison , WI 53711. For more information call 800-736-4648 in the US or 800-268-0425 in Canada. kEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY PURPOSES. This warranty does not cover products damaged by the following: Accident, misuse, abuse or alteration of the product Servicing by unauthorized persons Use with unauthorized accessories Connecting it to incorrect current and voltage Wrapping cord around appliance causing premature wear & breakage Any other conditions beyond our control No responsibility, obligation, or liability is assumed for the installation or maintenance of this product. [. . . ]