User manual REMINGTON R-830

[. . . ] Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Do not use an extension cord or a voltage converter with this appliance. Do not wrap the cord around the appliance. To disconnect, turn all controls to OFF, then remove plug from outlet. Do not use this appliance with a damaged or broken screen or cutters, as injury may occur. [. . . ] It is important to remove the headguard correctly to avoid damaging the clips that hold it to the shaver. Always keep the protective head guard on the shaver head and keep the trimmer in the OFF position when the shaver is not in use. ON/OFF Switch To activate the shaver, press in the locking bar while pushing the power button up. 3 Power System Corded shavers can only be used while they are plugged into an electrical outlet. To Trim Trim mustache Use the shaver heads to trim the lower edge of your mustache. Hold shaver at desired trim line for a quick, easy, professional trim. Trim sideburns Extend the trimmer and touch the edge of it to the desired trim line. Corded Operation of the R-830 and R-835 Slide the power button down to the OFF position. Connect the supplied AC power cord to the shaver's power port and then to an electrical outlet. To Shave 6 Push the ON/OFF button to activate the shaver for shaving. This allows the shaver to work the way it was designed for the closest shave and minimum wear. 7 28879_R800_revised series 11/4/05 4:02 PM Page 8 Cleaning and Maintenance To assure smooth, efficient performance, it is important to clean your shaver. Daily Brush inside the head assembly after each use: 1. Grip the head assembly by the three ridges and pull it off the shaver. Use the cleaning brush to sweep out the internal part of the head assembly and the hair pocket area, where 3 shaver spindles are located. Important: Make sure to align the two locating holes in the Cutter Retainer assembly with the pins in the Head Frame Assembly. Then tighten center screw knob to lock the cutters into place. Replace head assembly on the shaver simply by pushing it onto the shaver. When removing the headguard or placing it back onto the shaver, do not apply pressure to floating cutter surfaces, as you may damage them. Cleaning Cautions The construction of this shaver is for dry operation only. Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do not use an aggressive cleansing agent as this may destroy the shaver coatings. Do not clean or remove the head assembly while the shaver is running or plugged in, as it may cause damage to the unit's heads or cutters. Replace worn or damaged parts with Remington® replacement parts only. When is it Time to Replace Your Heads and Cutters? It is very important to replace your heads and cutters when necessary to ensure a close, comfortable shave without irritation. Here are some signs of head and cutter wear, indicating that replacement is needed. Irritation As the heads get excessively worn you may experience some skin irritation. This would be especially noticeable when you apply after-shave lotion. Pulling When the cutters wear you may feel a sense of pulling and a loss of closeness when you shave. This is an indication that it is time to replace your heads and cutters. [. . . ] ALL IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO TWO YEARS FROM DATE OF ORIGINAL PURCHASE. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province. Some states do not allow the exclusion or limitation of incidental, special or consequential damages. Patents: D486, 942: 5, 390, 416; 5, 408, 749 Canadian Patents: D100892: 2, 091, 039; 2, 114, 923; 2, 111, 626 REMINGTON & MICROFLEX are trademarks of ROVCAL, INC. [. . . ]