User manual REMINGTON MS-5500

[. . . ] s Except when charging, always unplug this appliance from the electrical outlet immediately after using. s Unplug this appliance before cleaning it. s Do not plug or unplug this appliance when your hands are wet. s Do not use an extension cord or a voltage converter with this appliance. Detach removable power cords from appliances for storage. s Do not use this appliance with a damaged or broken screen or cutters, as injury may occur. [. . . ] This means you have enough cleaning solution left for approxi mately 5 more cleanings. If the red light stops blinking and glows steadily, the unit will not operate until the solution and filter have been replaced. Replacing the Filter and Solution Only the Remington® special cleaning solution and filter can be used with the Smart System. The cleaning solution contains a high percentage of alcohol and a special oil that lubricates your shaver each time it is cleaned. The filter is specially designed to collect hair debris yet allow for the system to clean your shaver. To refill the cleaning solution and replace the filter, follow the steps for "Preparing the System" above. But before replacing the upper portion of the unit, rinse out the tank with fresh water and allow it to air dry to remove any sediment. Wipe off the unit periodically with a damp cloth and remove any hair debris that has collected where the shaver sits. To Charge Your Shaver The MS-5500 and MS-5700 can also be recharged by plugging it into the cord directly. s Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. A charging indicator light will come on. s Your shaver cannot be overcharged, so you can leave it plugged in and charg ing between shaves. s To preserve the life of the batteries, let them fully run out every six months, then recharge them for a full 24 hours. s Cord/cordless rechargeable shavers can run directly off the cord if necessary. They will not recharge while you are shaving, so after shaving with the cord, turn the unit off and set it aside to charge. Cord/cordless shavers should not be used strictly as cord-operated shavers, as continued cord-only use will result in reduction of battery life. s Quick Charge provides up to three weeks of shaving after a one-hour charge, or a single shave after a five-minutes charge. s If your shaver's charge runs out in the middle of a shave, you can push the power reserve button to get an extra 5 minutes of power. NOTE: If your shaver battery is completely discharged or the shaver has not been used for a long time, the shaver may not start when operated using the cord. If this happens, charge the shaver for approximately five minutes before shaving. Preparing the System Cleaning solution: 1. Press the latch but tons on the sides of the cleaning base and lift the upper portion off the unit. You will need to keep the buttons pressed in as you move the upper portion away from the base. The cleaning solution tank is in the unit's bottom portion. Remove the filter from the tank and set aside. Operating the Charging/Cleaning System Plug the power cord into the cleaning base and then into an electrical outlet. 2 Place the shaver into the unit, head side down, and slide its "tail"toward the "neck"of the base until it clicks into place. Charging Your shaver automatically begins to recharge as soon as it clicks into place in the cleaning base. While it is charging, the green indicator light will flash; when it is fully charged the green light will stop blinking and glow steadily. Cleaning To activate cleaning mode, simply press the CLEAN button on the cleaning base. The yellow indicator light flashes through the entire cleaning cycle, which lasts approximately 25 minutes. When the cleaning cycle has been completed, the yellow light will stop blinking and glow steadily. Pour the bottle of cleaning solution into the base of the unit through the opening where the filter was removed. NOTE: It is important to make sure the filter is in place. The filter collects hair clippings and debris, and should be replaced along with the solution. Failure to do so will permanently clog the system rendering it inoperable. !To avoid damage to the cleaning system, use only Remington special cleaning solution. [. . . ] Or visit www. remington-products. com Rayovac Corporation 800-736-4648 MADE IN CHINA Performance Guarantee Performance Guarantee Rayovac Money-Back Offer If within 30 days after you have purchased your Remington brand product, you are not satisfied with it and would like a refund, just return it, together with the sales receipt, to the retailer from whom it was purchased. Rayovac will reimburse all retailers who accept such appliances within 30 days from date of purchase. If you have any questions regarding this money-back guarantee, please call 800-736-4648 in the U. S. or 800-268-0425 in Canada. Full Two-Year Warranty Rayovac warrants that this product is free from defect in material and workmanship for two years after its original purchase date--except for damage as specified below and these parts meant to be replaced during regular maintenance: s SHAVERS:head assembly s SMART SYSTEM:filter If the product should become defective within the warranty period, Rayovac will repair it or elect to replace it free of charge. We will return your product, shipping charges prepaid, if you do the following within two years of the purchase date: 1. Return the complete product in person or by mail, postage paid, to an authorized service dealer. This warranty does not cover products damaged by the following: s Accident, misuse, abuse or alteration of it s Servicing by unauthorized persons s Use with unauthorized accessories s Connecting it to incorrect current and voltage s Any other conditions beyond our control No responsibility, obligations, or liability is assumed for the installation or maintenance of this product. [. . . ]