User manual REMINGTON DA-107

[. . . ] Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. Do not use this shaver with a damaged or broken cutter or head, as facial injury may occur. To disconnect, turn all controls to "Off, " then remove plug from outlet, then detach power cord from the shaver for storage. To prevent possible damage to the cord, do not wrap cord around the shaver. [. . . ] Using your finger tip, spread the oil along the teeth, and run the trimmer for a few seconds. Before operating your MicroScreen® 2 Shaver, remove the Headguard, which protects the Foils and Cutter Assembly. Because they are subject to daily use, the cutters and foils of your Remington® MicroScreen® 2 Shaver will wear and eventually require replacement to maintain a close, comfortable shave. Depending on your shaving technique and habits, the foils will usually last six months; the cutters, one year. Some signs that your foils and cutters need replacing are: s Irritation. As foils get worn, you may notice your skin feeling sensitive after a shave, particularly when you apply aftershave. As cutters wear, your shave may not feel as close, and you may feel your shaver is pulling at your whiskers. To prevent inadvertent damage to the Foils and Cutter Assembly, do not attempt to remove them unless you are replacing them. To remove the old foil and cutters follow the instructions that come with the foil and cutter replacement package. It's always a good idea to replace the foils when you replace the Cutter Assembly. Model DA-307 and DA-325 With the shaver unplugged, press in on the Switch Lock and slide the ON/OFF button upward to turn ON. Note that this shaver is designed only to operate from its batteries; it must be charged before using. Model DA-407, and DA-757 These shavers can be powered from either the cord or the batter y. To shave using the batter y, make sure that the shaver has been charged. To shave using the cord, connect cord to shaver and then to electric outlet. If your DA-407, 757 shaver battery is completely discharged or the shaver has not been used for an extended period of time, the shaver may not start when operated using the cord. If this condition occurs, charge the shaver for approximately five minutes before shaving. S Your DA-407, 757 cord/cordless shaver should not be used strictly as a cordoperated shaver, as continued cord only use will result in reduction of battery life. S In order to preserve the life of the batteries, they should be fully discharged every six months and then fully charged for 24 hours. Use of a shaver at voltages other than the ones specified below will damage it and void the warranty. (Cord/Cordless and Cordless Rechargeable Models Only) When your rechargeable shaver reaches the end of its useful life, the batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your local and state requirements. The following procedure should be followed for battery removal: Remove the head assembly by pushing in on the head assembly release buttons. [. . . ] Remington will correct any such defect without charge if you return the complete product either in person or by mail, postage paid, to a Remington Company-owned Service Center or Authorized Service Dealer within one year after date of purchase. Do not return the product to the retailer from whom the product was purchased. This warranty does not cover damage by accident, misuse, abuse or by affixing an unauthorized accessory or alteration to the product, or by connection of the product to any but the specific current and voltage indicated in an accompanying instruction booklet, or by any other conditions beyond our control. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state. [. . . ]