User manual POWER ACOUSTIK PLASMA 1 INSTALL GUIDE

[. . . ] B C MIC INSTALLATION & CONNECTIONS PLASMA 1 INSTALLATION & CONNECTIONS: The PL-1 is designed to provide you with many years of continuous use without failure. [. . . ] After you've done that, the next step is to decide on a particular mounting style; as you can see, the choices are table-top (mounting stand provided) and panel-mount. If you choose panel mounting, use the snap-ring (provided) as a template to mark the cut-out area where you would mount the display. Please avoid installing the display in high temperature areas, where temperatures can exceed 50 deg. F. If you prefer to use the display in locations other than your vehicle, simply purchase and AC adapter which provides a regulated 12 volt output @ 500 milliamps and follow the same steps as above. ELECTRICAL CONNECTIONS & Speci cations: · Connect the negative (-) side of the signal source to the same point (GND) as the DC power source or negative power terminal. Note that if the signal source and the PL-1 share a common power source, (example in-car installation) there is no need for this connection (one or two wires on this tab) · Connect the positive (+/signal carrying) side of the source signal to the tab marked "signal input" (one wire to this tab). [. . . ] If the veins appear too heavy or concentrated, lower the input signal, as continued use at this level, can cause premature damage to the unit. WWW. POWERACOUSTIK. COM [. . . ]