User manual POWER ACOUSTIK MD-1040CMX

[. . . ] First; understand what type of visual information the M-4 system provides. [. . . ] Assuming you have decided on the separate / individual mounting system, where each meter is situated in various locations, the next steps are (a) locate & identify each of the meters and each of the 4 separate / independent line-feeds ­ one for each meter. (b) open the DIN chasis and carefully remove the larger control box; the box would now be installed in the location of your choice. After you've done that, make electrical connections as per the instructions below in "ELECTRICAL CONNCETIONS" section. a) ISO DIN mounting: This type of installation is exactly like installing a car stereo; make sure there's adequate space inside the dash cavity and avoid severely disrupting existing wiring and connections for other existing equipment. Locate the B+ (RED) wire connection and connect it to an established + 12V DC source. Connect the Left RCA jack to the Left signal source and the Right RCA jack to the Right signal source. Install the control-box(es) in a location which allows for easy access, in the event that troubleshooting is necessary. Do not situate the box in areas of the vehicle where temperatures will exceed 50 deg. [. . . ] Please make sure that neither the main input wire harness nor the individual feed-lines are stressed; as this may result in premature cable breakage and overall failure. [. . . ]