User manual POLARIS NRX-4

[. . . ] 5. 6. 7. 8. 9. 10 Number Keypad ABC DEF FLASH 1 GHI 2 5 TUV JKL 3 HOLD MNO Flash Button Hold Button Tel No: EXT: 4 PQRS 6 9 CONF Conference Call Button Line 2 WXYZ LINE 2 7 8 0 LINE 1 Line 1 SPEAKERPHONE REDIAL Speakerphone Button VOLUME CONTROL Last Number Redial Volume Step Up/Step Down Control Buttons 3 7923 NRX4_Brochure2. qxd 8/12/2003 2:08 PM Page 4 NRX-4 - The Two Line Telephone with Conference Facility 1. INSTALLATION The Model NRX4 telephone requires no batteries to be fitted as the memories are stored in EEPROM solid state memory which does not require battery backup. Connect one end of the coiled cord to the handset and the other end to the socket at the left of the base unit. [. . . ] Repeat steps 2 to 4 for successively storing more than one telephone number. The programming can be enabled and disabled by means of the following key sequence: 1. 1 1. 2 To disable the programming [STORE] [VOL UP] [STORE] [0]. To enable the programming [STORE] [VOL UP] [STORE] [1] 2. 7 Memory Dialling To dial a telephone number that has been stored in one of the direct memory locations 1. When you hear the dial tone, press one of the memory location buttons. 2. 8 Privacy (Muting the Microphone during Conversation) During a telephone conversation, you may switch off the microphone in the handset by pressing the Mute button on the handset. As long as the handset Mute button is pressed, the microphone mute function is activated. Releasing the handset Mute button will re-enable the microphone for conversation. 2. 9 Modem/Data Connection Socket The NRX4 telephone has an additional socket marked MODEM, which allows the user to connect an extra telephone, modem or fax machine to the telephone line. This socket is at the back panel of the base cabinet and has a removable plastic cover. 5 7923 NRX4_Brochure2. qxd 8/12/2003 2:08 PM Page 6 NRX-4 - The Two Line Telephone with Conference Facility 2. 10 Message Waiting The NRX4 has a built in LED and neon lamp for message waiting indication. A message waiting switch is built inside the switch compartment located on the base bottom. This switch enables the LED to detect two different line reversal signals by selecting switch position 1 or 2. For 90V DC or AC message waiting signalling PABX's the neon is used for indication. Set the position of the switch to off, as the LED is not needed for indication. Please note the compartment door should be replaced when settings completed. 2. 11 Last Number Redial If you dial a number and find it is engaged or there is no reply, replace the handset or depress the speaker button. The number will be retained in the memory until you dial a different number. [. . . ] Re-install the wall mount bracket to the bottom cabinet for the wall mount position. Position the wall mount slots on the bracket of the unit over the two screws on the wall. Beneath the earpiece section of the cradle you will find a small tab. [. . . ]