User manual POLARIS NRX-1

[. . . ] INSTALLATION Connect one end of the coiled cord to the handset and the other end to the socket at the left of the base unit. Connect one end of the telephone line cord to the socket at the back of the unit and connect the other end to the telephone socket at the wall. After connecting the telephone to the line socket, the handset should be lifted to check dial tone is being received. If the handset is not lifted, the telephone will take about 15 seconds to power up during which time any incoming calls will not ring the unit. 2. [. . . ] This will be stored in the Last Number Redial memory and be automatically inserted in the number when the LNR button is used. 2. 5 Other Network Services The NRX-1 is fully compatible with many telephone network services, which provides a number of useful additional facilities, including three way calling, call diversion, call waiting etc. If you are connected to one of the digital exchanges, you can access these services via the Recall button on the keypad. The recall facility of this product may not always operate correctly on some parts of the telephone network or on some PABXs available on the NZ market. If this is the case then "recall" can be activated by 'flashing' the switch-hook or by repeated use of the recall. Recall problems with this product are not to be reported to Telecom Faults Service. 2. 6 Message Waiting The NRX-1 has a built in LED neon lamp for message waiting indication. A Message waiting switch is built inside the compartment under the unit. This switch enables the LED to detect two different line signals by selecting switch position 1 or 2. For 90V DC or AC message waiting signaling PABX the neon is used for indication. Set the position of the switch to OFF as the LED is not needed for indication. Please note the compartment door should be replaced when settings completed. 2. 7 Last Number Redial If you dial a number and find it is engaged or there is no reply, replace the handset. The number will be retained in the memory until you dial a different number. What you do: Lift the handset or press the NEW CALL key Press the "REDIAL" button. 5 8733 NRX-1_User Guide. qxd 8/12/2003 2:01 PM Page 6 NRX-1 - The telephone for the corporate user 2. 8 Adjustable Ringing Volume On the right of the unit is a switch, this adjusts the ringing volume of incoming calls. In addition to the ringing tone there is a Ring Indicator Lamp on the unit that will flash when the telephone is ringing as a visual indication. 2. 9 Adjustable Ringing Tone Pitch The ringer tone ringer melody repetition rate can be adjusted in off hook condition, as follows: Pitch 1 2 3 Setting Code `Mute' + `#' + `3' + `Mute' `Mute' + `#' + `6' + `Mute' `Mute' + `#' + `9' + `Mute' 2. 10 Privacy (Muting the Microphone during Conversation) During a telephone conversation, you may switch off the microphone in the handset by pressing the Mute button on the telephone base. The mute LED will be flashing to indicate that the microphone is muted and the other party, on the other end of the telephone line is not able to hear your conversation. Press the Mute button again to release the Mute function and the LED will be off. As long as the handset Mute button is pressed, the microphone mute function is activated. [. . . ] WALL ­ MOUNTING THE UNIT The NRX-1 can be wall mounted using the wall mount bracket installed on the bottom of the unit. Dismount the wall mount bracket from the unit Place the wall mount bracket on the required position on the wall Drill two holes on the wall according to the distance as marked by two mounting holes. Re-install the wall mount bracket to the bottom cabinet for the wall mount position. Position the wall mount slots on the bracket of the unit over the two screws on the wall. [. . . ]