User manual PHILIPS RQ1095

[. . . ] - Empty the cleaning chamber and clean it thoroughly by rinsing it with hot tap water every 15 days. - The Jet Clean System thoroughly cleans but does not disinfect your shaver, therefore do not share the shaver with others. - The cleaning chamber of the Jet Clean System is not dishwasher-proof. - When the Jet Clean System is ready for use, do not move it to prevent leakage of cleaning fluid. [. . . ] Quick charge After the shaver has charged for 5 minutes, it contains enough energy for one shave. First insert the top of the shaver into the Power Pod (1) and then press the bottom part into the Power Pod (2). Note:The shaver cannot be placed in the Power Pod when the protection cap is on the shaving unit. Place the shaver upside down in the holder with the display pointing towards the front of the Jet Clean System. Note: RQ1090, RQ1060 only: when you turn the shaver upside down, the indications on the display are also turned upside down so you can still see the remaining battery capacity. Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit. , The display shows that the shaver is charging (see chapter `The display'). Using the shaver shaving 1 Press the on/off button once to switch on the shaver. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. , The display lights up for a few seconds and then shows the remaining battery capacity (RQ1090/ RQ1060 only). Trimming You can use the trimmer to groom your sideburns and moustache. , The display lights up for a few seconds and then shows the remaining battery capacity (RQ1090/ RQ1060 only). Then press the shaving unit downwards (2) to attach it to the shaver (`click'). Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. - The best and most hygienic way to clean the shaver is in the Jet Clean System. You can also rinse the shaver under the tap or clean it with the brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. - Clean the shaver after every shave for optimal shaving performance. Cleaning the shaving unit in the Jet clean system The Jet Clean System has three cleaning programs: the eco program, the normal program and the intensive program. Preparing the Jet clean system for use Fill the cleaning chamber before first use. Simultaneously press the release buttons on both sides of the cleaning chamber (1). Unscrew the cap from the bottle with cleaning fluid and remove the airtight seal. [. . . ] If the fluid volume in the cleaning chamber drops below the minimum level during the cleaning program, the program aborts. The cleaning light and the `cleaning chamber empty' symbol flash at intervals and the holder returns to its starting position. refill the cleaning chamber with cleaning fluid up to the MAX indication (see chapter `Cleaning and maintenance'). - You may have used another cleaning fluid than the original Philips cleaning fluid. [. . . ]