User manual PHILIPS MCM166

[. . . ] p Apparatus shall not be exposed to dripping or splashing. j Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 4 EN q Do not place any sources of danger on the apparatus (e. g. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www. eiae. org. s Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning · Never remove the casing of this micro hi-fi. [. . . ] a POWER · Turn on the micro hi-fi, switch to standby mode, or switch to Eco Power Standby. b Source selection keys (DISC, TUN, USB, MP3 LINK) · Select a source: CD, TUNER, USB or MP3 LINK. Jack for a USB mass storage device. EN 9 English Overview of the remote control d SHUF · Play tracks randomly. f · · · g · / Skip to the previous/next track. Adjust time. p DSC · Select a preset sound setting: POP, JAZZ, CLASSIC or ROCK. s REP · Play a track repeatedly. h DBB · Turns on or off dynamic bass enhancement. · Select a preset radio station. 10 EN 3 Connect Connect speakers Connect power English Note · Insert the stripped portion of each speaker wire into · For optimal sound, use the supplied speakers only. · Connect only speakers with impedance that is the same or higher than the supplied speakers. Ensure that the power supply · voltage corresponds to the voltage printed on the back or the underside of the micro hi-fi. Before connecting the AC power cord, ensure you have completed all other connections. To insert each speaker wire: Hold down the socket flap. Release the socket flap. 1 Connect the AC power cord to the wall socket. 1 2 1 2 3 4 5 For the right speaker, find the sockets on the main unit marked `RIGHT'. For the left speaker, find the sockets on the main unit marked `LEFT'. Repeat steps 2-3. EN 11 4 Get started Caution · Use the controls only as stated in this user manual. · Note · Before pressing any function button on the remote control, first select the correct source with the remote control instead of the main unit. If you are not going to use the remote control for a long time, remove the battery. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of your micro hi-fi. » The clock (if set) appears on the display panel. To switch the micro hi-fi to Eco Power Standby mode: 1 In the standby mode, press and hold POWER for more than 2 seconds. » The backlight on the display panel turns off. EN 13 5 Play disc/USB Play disc 1 2 3 4 Press DISC to select the disc source. on the top panel to 1 2 3 4 5 Insert the USB plug of a USB device into the socket. to start play. Insert a disc with the printed side facing up, then close the disc tray. Press to start play. Play from USB Note · Ensure that the USB device contains playable audio contents for supported formats (see `USB playability information' on page 20). 14 EN 6 Play options Skip to a track For CD: Repeat play Play a track repeatedly 1 2 1 1 1 2 During play, press REP. » [REP] (repeat) is displayed: the current track is played repeatedly. [. . . ] · Reduce the distance between the remote control and the micro hi-fi. · Insert the battery with its polarities (+/­ signs) aligned as indicated. · Aim the remote control directly at the sensor on the front of the micro hi-fi. · Wait until the moisture condensation at the lens has cleared. [. . . ]