User manual PHILIPS HR1565/50

[. . . ] Warning -- Check if the voltage indicated on the bottom of the appliance Corresponds to the local mains voltage before you connect the appliance. -- Do not use the appliance if the mains cord, the plug or other parts are damaged. -- If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard. [. . . ] Make sure you insert the beater or kneading hook with the plastic collar into the larger opening in the bottom of the mixer(Fig. If necessary slightly turn the beaters or kneading hooks while you do this. -- For the best result, first put the liquid ingredients into the bowl and Then add the dry ingredients. 7 Press the holder release button and bring the mixer into a horizontal position so that the beaters or kneading hooks are lowered into the ingredients(Fig. -- Press the turbo button to mix more quickly or to increase the speed -- Press the spatula against the side of the bowl to remove unmixed 9 When you have finished mixing, set the control slide to 0 and unplug the appliance. 10 Press the holder release button and tilt the holder with the mixer on it backwards. 11 Push the control slide forward to the eject position to release the beaters or kneading hooks and remove them from the mixer(Fig. 12 Press the mixer release lever at the rear end of the mixer holder (1) and lift the mixer off the holder (2)(Fig. Note:The mixer canbe removed from the holder when it is in tilted position orin horizontal position. 1 Insert the beaters or kneading hooks into the mixer (follow the procedure as described above at point 3 in section `Mixing on the stand'). 3 Lower the beaters or kneading hooks into the ingredients and switch on the mixer. Press the turbo button to mix more quickly or to increase the speed during heavy jobs, e. For the right quantities and times, see the table `Quantities and processing times'. 4 If you want to stop mixing for a while, switch offthe appliance and put it (with the beaters or kneading hooks still attached) on its heel until you continue(Fig. 5 When you have finished mixing, set the control slide to 0 and switch offthe appliance. 6 Push the control slide forward tothe eject position to release the beaters or kneading hooks and remove them from the mixer(Fig. caution: Do not use aggressive cleaning agents or abrasive cleaning materials , such as scouring pads. 1 Clean the beaters, the kneading hooks and the spatula in warm water with some washing up liquid or in the dishwasher. [. . . ] For at få fuldt udbytte af den support, Philips tilbyder, skal du registrere dit produkt på www. -- Apparatet bør holdes uden for børns rækkevidde for at sikre, at de ikke kan komme til at lege med det. 12 Appuyez sur le levier de dégagement du batteur à l'arrière du support (1) et soulevez le batteur du support (2)(fig. [. . . ]