User manual PHILIPS GC7430/02

[. . . ] Indd 6 23-10-09 10:01 English -- If steam escapes from under the Calc-Clean rinsing cap when the appliance heats up, switch off the appliance and tighten the Calc-Clean rinsing cap. If steam continues to escape when the appliance heats up, switch off the appliance and contact a service centre authorised by Philips. -- Never remove the Calc-Clean rinsing cap when the steam tank is hot. -- Do not use any other cap on the steam tank than the Calc-Clean rinsing cap that has been supplied with the appliance, as this cap also functions as a safety valve. [. . . ] 4 Put the mains plug in a wall socket and set the on/off switch to on (GC7420) or press the on/off button (GC7430) (Fig. Note:When you switch on the appliance, the steam tank produces a pumping sound. This sound is normal and indicates that water is being pumped into the steam tank. , , The power-on light on the steam tank and the iron temperature light go on to indicate that the steam tank and the iron start to heat up. , , GC7430: The high steam setting light flashes to indicate that the steam tank is heating up. 2 minutes, the steam setting light stays on continuously, to indicate that the water in the steam tank is hot enough for steam ironing. 5 GC7430: Press the steam setting selector to set a steam setting suitable for the selected ironing temperature:  (Fig. Note: During ironing, the temperature light goes on from time to time. €8) -- If you want to use the steam function continuously, slide the steam lock to the locking position. Ironing without steam (GC7430 only) Do not press the steam activator while you iron. 1 Set the required ironing temperature (see chapter ‘Preparing for use’, section ‘Setting the temperature’). €5) 2 Put the mains plug in a wall socket and press the on/off button (Fig. , , If the steam tank is empty or has not heated up yet, you hear a clicking sound inside the tank. This sound is caused by the opening of the steam valve and is perfectly harmless. 3 Put the iron on the iron platform and let the appliance cool down before you start to clean it. 1 To steam iron hanging curtains and clothes (jackets, suits, coats), hold the iron in vertical position (Fig. During steam ironing, you can use the steam boost function to remove stubborn creases. Note: Some water droplets may appear when you use the steam boost function for the first time. The water droplets disappear after you have used the steam boost function for some time. € ‘Water tank empty’ light (GC7430 only) -- When the water in the water tank runs low during use, the ‘water tank empty’ light goes on (Fig. 1 Refill the water tank (see chapter ‘Preparing for use’). Cleaning and maintenance Never immerse the iron and the steam tank in water or any other liquid, nor rinse them under the tap. [. . . ] , , GC7430: Indikatoren for høj dampindstilling blinker for at angive, at damptanken varmer op. € Lysindikator for “Tom vandtank” (kun GC7430) -- Når damptanken løber tør for vand under strygningen, tænder indikatoren for tom vandtank (fig. €1) A B C D E F G H I J K L M N O Slange Håndtak Temperaturbryter Temperaturlampe Damplås Dampaktivator Dampstøtknapp (kun GC7430) Strykesåle Lokk til påfyllingsåpning Påfyllingsåpning Strykejernplattform Vannbeholder Dampbeholder GC7420: Kontrollpanel 1 Av/på-knapp GC7430: Kontrollpanel  1 Av/på-knapp med på-lampe 2 Lampe som lyser når vannbeholderen er tom 3 Dampinnstillingsvelger 4 Damplamper Ledning Holder for Calc-Clean-tablett Ledningskrok Lokk for Calc-Clean-rens Viktig Les denne brukerveiledningen nøye før du bruker apparatet, og ta vare på den for senere referanse. Elektromagnetiske felt (EMF) Dette Philips-apparatet overholder alle standarder som gjelder for elektromagnetiske felt (EMF). [. . . ]