User manual PHILIPS FR986

[. . . ] To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] Do not expose the receiver to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). The display of the receiver is divided into 4 sections, which are to be used for the following: Speaker diagram Signs showing you various settings and information about the status of the receiver. Incoming multi channel signals are being reduced to fewer output signals (depending on the number of speakers). Optical digital input OPTICAL IN is being used for the playing source (FR 985, FR 986 only). Optical digital input OPTICAL 1 IN is being used for the playing source (FR 995, FR 996 only). Optical digital input OPTICAL 2 IN is being used for the playing source (FR 995, FR 996 only). * SELECT INPUT Assigns the audio input connectors to the different source selections chosen with SOURCE SELECT (see "SOURCE SELECTION" for details). If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus sockets (see "CONNECTIONS"), you may use the TV to set up the system. Press CINEMA LINK to switch the connection between the receiver and the TV either on or off. If CINEMA LINK is switched on and the TV menu is active, TV MENU is displayed and the menu and sound functions on the receiver are locked. When selecting a source by turning SOURCE SELECT, the audio and video inputs with the corresponding name are activated. the incoming signal is reproduced by all audio and ­ if the source includes a video signal ­ video outputs of the receiver. It is possible to reassign a source selection to other than these standard inputs. Using one source selection for two or more appliances You may assign more than one source to a source selection. This can be useful when products are connected one after the other in a chain. example: A VCR is connected to the TV but only the TV is connected to the receiver. Both SOURCE SELECT settings, TV as well as VCR, have to use the TV input connectors. 3 Turn X MENU NAVIGATOR to select the input connectors which should be used (e. The 6 CHANNEL / DVD INPUT connectors can be assigned to any of the available sources (excluding TUNER and PHONO). The 6 CHANNEL / DVD INPUT can be used to connect a device with a built-in multichannel decoder (e. When using the 6 CHANNEL / DVD INPUT audio input, the receiver works as a multichannel amplifier. The source reproduces surround sound and sends it to the receiver divided into the necessary channels. [. . . ] Announcement functions only work if the necessary RDS signals are being broadcast. if RDS stations are also carrying an EON signal (Enhanced Other Networks) , EON is displayed. This signal enables the tuner to search not only the chosen RDS station, but the whole EON station network for news and traffic information. 2 Press NEWS/TA: Once to display NEWS, this switches on the news announcement function. [. . . ]