User manual PHILIPS DS3120

[. . . ] Register your product and get support at www. philips. com/welcome DS3120 EN User manual Contents 1 Important 2 Your Docking Speaker Introduction What’s in the box Overview of the main unit 3 4 4 4 4 3 Get started Connect power Turn on 5 5 6 4 Play Play from iPod/iPhone Play from an external device Adjust volume 6 6 8 9  6SHFLÀFDWLRQV $PSOLÀHU General information   9 6 Troubleshooting 7 Notice 10 10 EN 2 1 Important ‡ ‡ ‡ ‡ ‡ Read these instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or RWKHU DSSDUDWXV LQFOXGLQJ DPSOLÀHUV WKDW produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. [. . . ] Battery power Low Full Empty LED indicator Flashing Steadily on Off Note ‡ The type plate is located at the back of the unit. To recharge the built-in battery: ‡ Connect the docking speaker to the power supply. » In standby mode, the LED indicators are off. Note ‡ Use the supplied AC adapter only to charge the battery. Connect the AC power adaptor to: ‡ the power socket at the back of the docking speaker. ‡ the wall socket. 5 EN Turn on Press to turn the docking speaker on. » The / LED indicators light up. 4 Play Play from iPod/iPhone You can enjoy audio from your iPod/iPhone through this docking speaker. Compatible iPod/iPhone The docking speaker supports the following iPod and iPhone models: Made for. ‡ iPod touch (1st, 2nd, 3rd, and 4th JHQHUDWLRQ ‡ iPod classic ‡ iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th JHQHUDWLRQ ‡ iPhone 4S ‡ iPhone 4 ‡ iPhone 3GS ‡ iPhone 3G ‡ iPhone Switch to standby mode The docking speaker switches to standby mode in the following situation: ‡ Press again; ‡ In AC power supply, the speaker is idle for 15 minutes; or ‡ In battery power supply, the iPod/iPhone or external audio device is disconnected from the speaker. » In standby mode, the / LED indicators are off. Listen to the iPod/iPhone To enjoy more features, you are recommended to install the free DockStudio app. 1 2 Press to turn the docking speaker on. Insert the iPod/iPhone into the dock. EN 6 3 4 5 )RU ÀUVWWLPH XVH \RX ZLOO EH DVNHG WR install DockStudio app on your iPod/ iPhone. Follow the on-screen instructions to complete the installation. 1 , I D QHZ ÀUPZDUH XSGDWH LV IRXQG WDS OK. 6 7 Launch the app after the installation. » Audio comes out through this docking speaker. Note 2 Follow the on-screen instructions to FRPSOHWH WKH ÀUPZDUH XSGDWH ‡ With the DockStudio app, you can enjoy music, set clock and alarm, adjust sound settings, and update ÀUPZDUH LI QHFHVVDU\ 8SGDWH ÀUPZDUH , I ÀUPZDUH XSGDWH LV DYDLODEOH WKH DockStudio app will search for it automatically and ask you to download it. Note ‡ Make sure that your iPod/iPhone is inserted in the docking speaker and connected to the Internet. 7 EN 1 2 3 4 Insert the iPod/iPhone in the dock. » The docked iPod/iPhone is synchronized with PC successfully through the iTunes. Note ‡ Due to different materials and product techniques, some USB cables may not work with this device. Note ‡ Do not disconnect power or undock the iPod/iPhone during the updating process. Play from an external device With this docking speaker, you can also enjoy audio from an external device such as an MP3 player. Note ‡ Make sure that no iPod/iPhone is docked in the speaker. Charge the iPod/iPhone Note ‡ If the docking speaker is operated on the batteries, you cannot charge your iPod/iPhone. When the docking speaker is connected to AC power, the docked iPod/iPhone begins to charge. Tip ‡ For certain iPod models, it may take up to a minute before the charging indication appears. 1 2 Press to turn the docking speaker on. &RQQHFW WKH 03 OLQN FDEOH QRW VXSSOLHG to: ‡ the MP3-LINK socket at the back of the docking speaker. Play audio on the device (see the device’s XVHU PDQXDO Sync iPod/iPhone with PC Note ‡ 0DNH VXUH WKDW L7XQHV KDV EHHQ FRQÀJXUHG SURSHUO\ in your PC. 3 EN 8 Adjust volume To adjust volume: ‡ Press +/- on your docking speaker; or ‡ Adjust the volume control of your iPod/ iPhone or external device. 5 Specifications Note ‡ Product information is subject to change without prior notice. $PSOLÀHU Rated Output Power 2 X 5 W RMS General information Power supply - AC Power Model: AS190-090$,  3KLOLSV Input: 100-240 V ~, 50/60Hz, 0. 7A; Output: 9 V 1. 9 A Li-ion battery <10 W <0. 5 W 5V 1A Tip ‡ If the docking speaker is powered by batteries, the volume is lower than that by AC supply. - Battery Operation Power Consumption Standby Power Consumption Max. load for iPod/ iPhone Dimensions - Main Unit : [ + [ ' Weight - Main Unit - With Packing 224 x 162 x 120 mm 1. 1 kg 1. 6 kg 9 EN 6 Troubleshooting Warning ‡ Never remove the casing of this apparatus. 7 Notice $Q\ FKDQJHV RU PRGLÀFDWLRQV PDGH WR WKLV device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site ZZZSKLOLSVFRPVXSSRUW :KHQ \RX FRQWDFW Philips, ensure that the apparatus is nearby and the model number and serial number are available. [. . . ] Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. We have tried to make the packaging easy to VHSDUDWH LQWR WKUHH PDWHULDOV FDUGERDUG ER[ SRO\VW\UHQH IRDP EXIIHU DQG SRO\HWK\OHQH EDJV SURWHFWLYH IRDP VKHHW Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. 11 EN Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N. V. [. . . ]