User manual PHILIPS AJ1003

[. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the Safety i j k l apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. m Battery usage CAUTION ­ To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit: · Install the battery correctly. · Remove the battery when the unit is not used for a long time. [. . . ] · Switch between FM radio play, MP3 link input, and clock time display. MP3 LINK · Audio input jack (3. 5 mm ) for an external audio device. Display panel e f g h i j k l m n 3 Get started Caution · Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. ___________________________ Activate the battery Caution · Riskofexplosion!Keepbatteriesawayfromheat, sunshineorfire. When the apparatus is not used for long · Batteries contain chemical substances, so they should be disposed of properly. Neverdiscardbatteriesinfire. 1 Remove the protective tab to activate the battery. To replace the battery (See Figure B): 1 Open the battery compartment. 2 Insert one lithium CR2025 battery with correct polarity (+/-) as indicated. 3 Close the battery compartment. Connect power Caution · Risk of product damage!Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the apparatus. When you unplug the AC power adapter, always pull the plug from the socket. · Before connecting the AC power adapter, ensure you have completed all other connections. 1 Connect the power adapter to · the DC IN (DC 5V) jack on the back of the main unit. · the power socket. 5 Set time and date 1 2 3 4 5 6 7 8 1 In clock mode, press and hold SET TIME/PROG for 2 seconds. Repeat steps 2-3 to set the day. View the preset date Press DATE repeatedly. » The clock time, month, day and year are displayed consequently. 4 1 2 Listen to radio Press SOURCE repeatedly to turn on the radio. Press +/- (on + TUNING -) repeatedly to tune to a radio station. Tune to a radio station Adjust the volume 1 Press +/- (on - VOLUME +) repeatedly. Program radio stations automatically Note · You can program a maximum of 20 preset radio stations. 1 2 Press SOURCE repeatedly to turn on the radio. » All available stations are programmed in the order of waveband reception strength. » Thefirstprogramedradiostationbroadcastsautomatically. Program radio stations manually Note · You can program a maximum of 20 preset radio stations. 1 2 3 4 5 6 Press SOURCE repeatedly to turn on the radio. Repeat the above steps to program more stations. Tip · To overwrite a programmed station, program another station in its place. Select a preset radio station 1 2 Press SOURCE repeatedly to turn on radio. Press PRESET +/PRESET - to select a radio station. 5 Set the alarm timer Set the alarm time You can set two separate alarms. [. . . ] If the problem remains unsolved, go to the Philips web site (www. philips. com/support). When you contact Philips, ensure that your apparatus is nearby and the model number and serial number are available. No response from the unit · Disconnect and reconnect the AC power plug, then turn on the unit again. Poor radio reception · Increase the distance between the apparatus and your TV or VCR. [. . . ]