User manual PHILIPS AJ1000

[. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Safety i j k l m n Apparatus shall not be exposed to dripping or splashing. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. [. . . ] SLEEP · Set the sleep timer. c d e +/· Adjust the times of clock, alarm timer and sleep timer. AL1, AL2 · RADIO: Set the current radio station as alarm tone. · SET AL1/AL2: Activate the alarm time setup; display the set alarm time. FM ANT · Attached FM radio antenna. f g h i j k l 3 Get started Caution · Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. ___________________________ Connect power Caution · Risk of product damage!Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the apparatus. When you unplug the AC power cord, always · Before connecting the AC power cord, ensure you have completed 1 Connect the power adapter to the power socket. Set the clock time 1 2 3 Switch Clock Control to SET TIME. · Press - to decrease the time digits one by one. 4 1 2 Listen to radio Press RADIO ON/OFF to turn on the radio. · To turn off the radio, press RADIO ON/OFF again. Tune to a radio station Adjust the volume level 1 Rotate VOL clockwise or anti-clockwise. 5 Set the alarm timer Set the alarm time You can set two separate alarms. Note · Before you start, ensure that the time is set correctly. 1 2 3 Switch Clock Control to AL1 or AL2 (on SET AL1/AL2). Switch Clock Control to CLOCK. Turn on the alarm timer Note · Ensure the alarm time is set successfully. 1 Switch AL1/AL2 to BUZ or RADIO. » The buzz or FM radio is set for alarm tone. View the alarm time 1 Switch Clock Control to AL1 or AL2 (on SET AL1/AL2). » The preset alarm time is displayed. Repeat alarm 1 When the alarm rings, press REPEAT ALARM/SLEEP OFF. [. . . ] When you contact Philips, ensure that your apparatus is nearby and the model number and serial number are available. No response from the unit · Disconnect and reconnect the AC power plug, then turn on the unit again. Poor radio reception · Increase the distance between the apparatus and your TV or VCR. [. . . ]