User manual PHILIPS 40770-35-16

[. . . ] Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons. Do not let cord hang over edge of table or counter, or touch hot surfaces. Do not place on or near a hot gas or electric burner, or in a heated oven. [. . . ] The machine that you have bought allows for certain adjustments that will permit you to use it to its full potential. Press the " " button until the following page is displayed. Coffee is a natural product and its characteristics may change according to its origin, blend and roast. The Saeco coffee machine is equipped with a self-adjusting system that allows the use of all types of coffee beans available on the market (not including flavored or carmelized). ⷠThe machine automatically adjusts itself in order to optimize the extraction of the coffee, ensuring perfect compression of the beans to obtain a creamy espresso coffee that is able to release all the aromas, regardless of the type of coffee used. ⷠThe optimization process is a learning process that requires the brewing of a certain number of coffees to allow the machine to adjust the compactness of the ground coffee. ⷠAttention should be given to special blends, which require grinder adjustments in order to optimize the extraction of the coffee (see section "Coffee Grinder Adjustment"). In this way, the machine has been programmed to inform the user of the need to replace the filter. Note: When an "Intenza" filter must be replaced with a new one, the function must be reset. After that, enter the programming menu until the indicated window is displayed and select the "RESET" option; then press the " " button. Note: If the filter is already installed and you want to remove it, without replacing it, select the "OFF" option and then press the " " button. In this case, the machine will run an empty cycle and discharge any ground coffee into the dregdrawer. to brew coffee: · Press and release the " " button to select the pre-ground coffee function. Use the measuring scoop supplied with the machine to perform this operation. Warning: Dispensing may be preceded by short spurts of hot water and scalding is possible. The steam/hot water wand may reach high temperatures: Do not touch with bare hands. Before dispensing hot water, check that the following icon is displayed: When the machine is ready, proceed as follows: · In this way, all parts will be perfectly cleaned and free of any milk residue. Fill the cup with hot water to the desired level; to stop hot water dispensing, turn selector dial counterclockwise back to the " " position. Occasionally, after turning the selector dial, hot water may not be dispensed and the following icon may be displayed: Simply wait until the end of the warm-up phase, at which point hot water will be dispensed from the wand (Pannarello if supplied). When the machine is ready to brew coffee, turn selector dial counterclockwise to set it onto the " " position. Residual water may dispense from the steam/hot water wand (Pannarello, if supplied). The following icon is displayed during the preheating time required by the machine: Steam dispensing will begin when the following icon is displayed; soon after only steam will begin to come out. [. . . ] In this example, we want to explain how to programme the display contrast. TIMER (STAND-BY) This function allows you to adjust the time the machine will go into stand-by mode after the last brewing. CONTRAST This function allows you to adjust the contrast of the display to better view the messages. WATER HARDNESS This function allows you to adjust the water hardness in order to better manage machine maintenance: = very soft water = soft water = hard water = very hard water For more details, see the "Water hardness measurement" section. [. . . ]