User manual PANASONIC WV-BP330

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual PANASONIC WV-BP330. We hope that this PANASONIC WV-BP330 user guide will be useful to you.


PANASONIC WV-BP330 : Download the complete user guide (177 Ko)

You may also download the following manuals related to this product:

   PANASONIC WV-BP330 (182 ko)
   PANASONIC WV-BP330 (182 ko)
   PANASONIC WV-BP330 (338 ko)

Manual abstract: user guide PANASONIC WV-BP330

Detailed instructions for use are in the User's Guide.

[. . . ] Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amp and that it is approved by ASTA or BSI to BS1362. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer. IMPORTANT The wires in this mains lead are coloured in accordance with the following code. [. . . ] Do not use strong or abrasive detergents when cleaning the camera body. In case the dirt is hard to remove, use a mild detergent and wipe gently. Whether the camera is in use or not, never aim it at the sun or other extremely bright objects. Do not operate the camera beyond the specified temperature, humidity or power source ratings. Use the camera under conditions where temperature is between ­10°C - +50°C (14°F - 122°F), and humidity is below 90%. The input power source is 220-240V AC 50Hz for WV-BP330, 12V DC for WVBP332, and 24V AC 50Hz for WV-BP334. -4- MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS <WV-BP330> LL OFF ELC OFF DC Hi-Z INT AGC ON ALC BLC ON VIDEO G/L 75 V. PHASE WV-BP330 GEN-LOCK VIDEO OUT VIDEO LEVEL L H <WV-BP332> DC 12V IN OFF ELC OFF DC Hi-Z AGC ON ALC BLC ON VIDEO G/L 75 GEN-LOCK VIDEO OUT VIDEO LEVEL L H <WV-BP334> AC 24V IN GND LL OFF ELC OFF DC Hi-Z INT AGC ON ALC BLC ON VIDEO G/L 75 V. PHASE 1 2 GEN-LOCK VIDEO OUT VIDEO LEVEL L H -5- q Auto Iris lens Connector This connector is for connecting auto iris lens by a 4-pin male connector supplied as a standard accessory (Part No. w Back-focal Adjusting Ring This ring is adjusts the back-focal length or picture focus. Rotate this ring clockwise for a C-mount lens or counterclockwise for a CS-mount lens. e Lens (option) r Camera Mounting Screw Hole This hole is for mounting the camera onto a mounting bracket. t Power Cord (only WV-BP330) Connect this power cord to an electrical outlet of 220-240V AC 50Hz. y DC 12 V Input Terminal (DC 12V IN (only WV-BP332)) This terminal is for connecting the 12V DC power supply cord. u AC 24V Input Terminal (AC 24V IN (only WV-BP334)) This terminal is for connecting the 24V AC 50Hz power supply cord. i Synchronization Mode Selector (INT, LL (only WV-BP330 and WV-BP334)) Selects the camera synchronization mode from internal sync mode (INT) or line-lock mode (LL). INT: When no signal is supplied to the GEN-LOCK connector, the camera synchronization mode is set to internal 2:1 interlace. Whenever the gen-lock video signal is supplied to the GENLOCK connector, the camera synchronization mode is automatically set to external synchronization. LL: The camera synchronization mode is set to line-lock even if the gen-lock video signal is supplied to the GEN-LOCK connector. o AGC ON/OFF Selector (AGC ON, OFF) Selects the gain of the video amplifier as follows: AGC ON: When the lens iris is fully open under low light condition, a clear picture is obtained by automatic increase of the gain. OFF: A natural and low-noise picture is obtained under low light conditions. -6- !0 Automatic Light Control / Electronic Light Control Selector (ALC , ELC) Lets you select the mode according to the lens type that is used with this camera. ALC: Select this mode when an auto iris lens (ALC lens) is used with this camera. ELC: Select this mode when a fixed iris lens or manual iris lens is used with this camera. [. . . ] If the ring is rotated by force, the inner lens or CCD image sensor may be damaged. -14- INSTALLATION OF CAMERA · Mounting from the bottom This camera is designed to be mounted from the bottom, as shown below. The mounting hole is a standard photographic pan-head screw size (1/4" - 20). · Mounting from the top Remove the mount adapter from the bottom of the camera by removing the two fixing screws. Attach the mount adapter to the top as shown in the diagram, then mount the camera on the mounting bracket. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC WV-BP330




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC WV-BP330 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.