User manual PANASONIC PT-AE3000

[. . . ] PT-AE3000U Before operating this product, please read the instructions carefully and save this manual for future use. TQBJ0277-1 ENGLISH Important Safety Notice Dear Panasonic Customer: The following information should be read and understood as it provides details, which will enable you to operate the projector in a manner which is both safe to you and your environment, and conforms to legal requirements regarding the use of projectors. Before connecting, operating or adjusting this projector, please read these instructions completely and save this booklet with the projector for future reference. We hope it will help you to get the most out of your new product, and that you will be pleased with your Panasonic LCD projector. [. . . ] CURSOR RETURN SELECT ENTER DEFAULT COLOR TINT BRIGHTNESS PROFILE NORMAL CURSOR LOG PROFILE SAVE PROFILE DELETE PROFILE NAME CHANGE Adjusted color Create a new profile Adjusting the selected color Select a color and adjust COLOR, TINT and BRIGHTNESS. When the LOG is fully stored, the target cursor will not be displayed. €œPROCESSING” is displayed for a few seconds and the result is stored in LOG. Managing stored logs You can edit or delete the stored logs of the selected PICTURE MODE. Move the cursor with F G I H to the required place to select a color and press ENTER. The color at the center of the target cursor is sampled and the sample box is displayed on the left of the cursor. You may fail to adjust when the very edge point of the projection area is selected as sample. 26 - ENGLISH Remote control operation Saving a log setting as a profile Return to the COLOR MANAGEMENT menu and save the stored log as a profile. Deleting the saved profiles You can delete the profiles from PROFILE DELETE menu. Changing the profile names You can change the name of the profiles from the PROFILE NAME CHANGE menu. Use F G I H to specify the location of the required character to enter and press the ENTER button. Use F G I H to specify the location of the required character to enter and press the ENTER button. Select OK and press the ENTER button to set the entered text as a name. Move cursor to ALL DELETE and press the ENTER button to delete all the entered text line. Press the DEFAULT button to delete the last entered character or indicated with cursor in the text box. To insert a character in the entered text line, move the cursor to the text box to select the required place and press G then perform step 3. Select OK and press the ENTER button to set the entered text as a name. Press the ENTER button without entering any text to keep the default name. NOTE: • LOG and PROFILE SAVE are not displayed before you apply COLOR MANAGEMENT. €¢ When the LOG is fully stored, the CURSOR will not be displayed. €¢ If you load a profile with a different attribute mode of the profile, the CURSOR and PROFILE SAVE menus will not be displayed. • The approximate colors will be adjusted at the same time. [. . . ] When a command which does not require parameters to be sent, the colon (:) is not required. If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer. eNGLISH - 51 Appendix Technical Information Communication settings Signal level Sync. Method Baud rate Parity RS-232C Asynchronous 9 600 bps None Character length Stop bit X parameter S parameter 8 bits 1 bit None None Control commands Command PON POF Control contents POWER ON POWER OFF Remarks In standby mode, all commands other than the PON command are ignored. [. . . ]