User manual OCTEK WL-260

[. . . ] CardWizardNT is a trademark of SystemSoft Corporation. Introduction T he WL-260 is a high-performance PCI-to-PC Card Adapter that supports One PC Card socket compliant with the 16-bit PC Card standard defined in 1997 PC Card Standard. The WL-260 provides a rich feature set that makes it the best choice for bridging between PCI and PC Card in desktop computers. [. . . ] 2 Package Contents n the package of the WL-260, you will find following contents. Contact your local dealer if the package of your WL-260 does not contains following contents: * WL-260 Adapter x1 * User's Guide x1 *Setup Diskette x1 System Requirement To install and use the WL-260, your system must have: Hardware Requirement * IBM PC Compatible Computer x1 * Free PCI Expansion Slot x1 Software Requirement Microsoft Windows 95 OSR2 or Microsoft Windows 98 or Microsoft Windows 98 SE or Microsoft Windows NT 4. 0 (See Note. ) or Microsoft Windows 2000. Note. To make the PC Card hot-swapping function in Windows NT 4. 0 enabled, the software CardWizardNT released by SystemSoft is required and is not for free. Please contact your local dealer to get this software. Software Setup T he device driver software contained in the Setup Diskette is necessary for appropriate operation of the WL-260. Together with the special IRQ steering circuit embedded in the R5C475 II chip set, the driver software accomplish necessary hardware configuration and IRQ routing emulation for the WL-260. Included in the Setup Diskette are software drivers for various operating systems including Windows 95 OSR2/98/98 SE, Windows NT 4. 0, and Windows 2000. CardWizardNT by SystemSoft is required to support the PC Card hot-swapping function on Windows NT 4. 0. A Setup program is provided to automatically identify the running system and install corresponding software driver accordingly. Please follow the instructions to install the device driver software for your WL-260. Important Things You Should Know To setup the WL-260 on a computer with Microsoft Windows 2000, be sure to do the hardware setup first, then the software. In Microsoft Windows 95 OSR2/98/98 SE/NT 4. 0, that would be OK whatever setting up the hardware or the software first. About how to setup the hardware, please refer to Page 10. Software Setup Software Setup Procedure 1. Insert the Setup Diskette into the floppy disk drive of your computer. (where A: is the floppy disk drive letter) to execute the Setup program. Read through the Software License Agreement, and then click Yes to continue setup. [. . . ] Power ON your computer and re-start operating system. Specification * PCI Local Bus Specification Revision 2. 2 compliant. * Ambient temperature under bias 0C to 70C * Storage temperature -65C to 150C * PCI-to-PCMCIA host bridge R5C475 II * Max. [. . . ]