User manual NUMARK TT1510

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual NUMARK TT1510. We hope that this NUMARK TT1510 user guide will be useful to you.


NUMARK TT1510 : Download the complete user guide (144 Ko)

Manual abstract: user guide NUMARK TT1510

Detailed instructions for use are in the User's Guide.

[. . . ] Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked upon or pinched by items placed on or against them. When removing the cord from a power outlet be sure to remove it by holding the plug attachment and not by pulling on the cord. Object and Liquid Entry - Take care that objects do not fall into and that liquids are not spilled into the inside of the mixer. Cleaning ­ The appliance should be cleaned only as recommended by the manufacturer. [. . . ] Be careful not to twist the belt. Belt wrapped around underneath the platter BELT DRIVE SPINDLE 6. Installing the cartridge: When installing a cartridge, refer to the operating instructions of that cartridge. During installation, attach the stylus protector to guard the stylus tip from damage. If you have purchased a unit with the cartridge included, then that cartridge is already installed on the headshell (You may skip to line 8). White (L+) Left channel+ Blue (L-) Left channel Red (R+) Right channel+ Green (R-) Right channel b. Install the cartridge to the headshell and tighten it with screws provided with the cartridge. Insert the headshell into the front end of the tonearm, then turn the locking nut clockwise with the head shell firmly held horizontally. 9. Twist it lightly and it will screw onto the rear shaft of the tonearm. Tonearm Counterweight - The Leader in DJ Technology ©2000 Industries -5http://www. numark. com TT1510 10. Adjustment of horizontal zero (O) balance with stylus pressure and anti-skating : a. Set the cueing lever to the lower position so it does not effect tone arm height. Release the arm clamp and lift the tonearm from the armrest so it moves freely. Rotate the counterweight until the tonearm is approximately balanced horizontally (floats freely). e. Hold the counterweight stationary with one hand and rotate only the styluspressure ring to bring the number "O" of the ring into alignment with the center line on the tonearm rear shaft. Rotate the counterweight with scale ring clockwise to the correct stylus pressure following the manufacturer's recommendation. Set the anti-skating control knob to the same value as the stylus pressure unless your manufacturer specifies otherwise 11. If you need to remove the lid press both release tabs at the same time. CONNECTIONS 1. Connect the unit's output terminals from the rear of the unit to the PHONO jack of your DJ mixer or home amplifier/receiver. Output terminals L (White) --------------> R (Red) ----------------> GND (Spade) --------> Phono input of mixer L Channel R Channel GND Notes: Be sure to connect the ground terminal firmly to the amplifier or receiver. If this connection is not loose, a power source "HUM" may result. - The Leader in DJ Technology ©2000 Industries -6http://www. numark. com TT1510 OPERATING INSTRUCTIONS 1. When playing a 45rpm record with a large center hole, place the 45-rpm adapter on the center spindle. When play is finished, raise the cueing lever, move the tonearm to the armrest, and secure the tonearm with the arm clamp. Press the Start/Stop button to stop the platter rotating, push the power button to turn off the power. PITCH ADJUSTMENT The pitch control is variable in a range of +/-10%. [. . . ] Accordingly, additional statements such as dealer advertising or presentation, whether oral or written, do not constitute warranties by NUMARK and should not be relied upon. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO PURCHASER. You may also have other rights, which vary from one jurisdiction to another. RETURN INFORMATION a) b) c) d) e) f) g) A Return Authorization number must be obtained from Numark through the address or phone numbers below. A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE NUMARK TT1510




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual NUMARK TT1510 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.