User manual NOKIA RX-3

[. . . ] Other product and company names mentioned herein may be trademarks or tradenames of their respective owners. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused. Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. [. . . ] There are three ways Press briefly - press a key for less than one second · Press - press a key for longer than one second · Press and hold - press and hold down the key (the function remains activated until you release the key) Indicators on the display The indicator blinks when Medallion I is trying to connect to another device. This indicator is displayed continuously when IR connection is established, and is animated when Medallion I is sending or receiving an image. Five seconds Medallion I switches the power off but the charging continues. Note that when connecting the charger to Medallion I for the first time or if you have not used Medallion I for a long period, charge the device for at least five minutes before any information appears on the display. Switching the power on and off When the power is on, the brightness of the background lights changes randomly. When the lights are dim, press briefly to switch on the bright lights for approximately 15 seconds. Use of the lights increases the demand on battery power and reduces the battery life. If there is only one image in Medallion I, it is displayed when you switch on the power. If there is more than one image in Medallion I, · Sending an image from Medallion I When the power is switched on, select the image you want to send on the display of Medallion I. Direct the IR ports of Medallion I and the receiving compatible device to each other and ensure that there are no obstructions between the devices. Note that Medallion I may resize and crop the received images to display them. The originally received images are also saved and if you want to forward a received image, Medallion I sends the original. Direct the IR ports of Medallion I and the compatible sending device to each other and ensure that there are no obstructions between the devices. For more information on how to initiate the sending from the other device, refer to the user's guide When the image is successfully received, it is indicated with . When the power is switched on, select the image you want to delete on the display. To delete the image, press again and simultaneously within three seconds . Remember to make backup copies of your images by, for example, sending and saving them to another compatible device. When the power is Within five seconds, press and hold to run the clock forward and press and hold to run the clock backward. Note that a new battery's full performance is achieved only after two or three complete charge and discharge cycles!The battery can be charged and discharged hundreds of times but it will eventually wear out. [. . . ] High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics. When it warms up (to its normal temperature), moisture can form inside, which may damage electronic circuit boards. ⷠDo not use harsh chemicals, cleaning solvents, or strong detergents to clean Medallion I. If Medallion I is not working properly, take it to your nearest qualified service facility. [. . . ]