User manual NOKIA BLUETOOTH HEADSET BH-606

[. . . ] Diversion contrary to law is prohibited. Introduction With the Nokia Bluetooth Headset BH-606, you can make and receive calls while on the move. headset do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices. The headset is compliant with the Bluetooth Specification 2. 0 + EDR supporting the Headset Profile 1. 1 and Hands-Free Profile 1. 5. [. . . ] Ensure that your phone is on and When the headset is connected to the headset is off. Press and hold the power key (for indicator light flashes about every 5 about 5 seconds) until the seconds. Basic use Place the headset on the ear Slide the earloop behind your ear, and point the headset toward your mouth (9 and 10). To use the headset on ENGLISH the left ear, detach the earloop (11), flip it, and push it into place (12). To mute or unmute the microphone during a call, press the middle of the volume key. To switch a call between the headset and a compatible phone, press and hold the answer/end key (or the power key) for about 2 seconds. Calls To make a call, use your phone in the normal way when the headset is connected to it. To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the answer/end key twice. To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the answer/end key for about 2 seconds. To set the headset volume, slide the volume key up or down. Clear settings or reset To delete the pairings from the headset, switch off the headset, and press and hold the power key and the answer/end key for about 5 seconds. To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger that is connected to a wall outlet. Troubleshooting If you cannot connect the headset to your compatible phone, check that the headset is charged, switched on, and paired with the phone. ENGLISH Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, and DC-4. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, EB, X, AR, U, A, C, or UB. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Use of an unapproved charger may present a risk of fire, explosion, leakage, or other hazard. If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. [. . . ] When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards. Rough handling can break internal circuit boards and fine mechanics. ENGLISH · Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. These suggestions apply equally to your device, charger, or any accessory. If any device is not working properly, take it to the nearest authorised service facility for service. [. . . ]