User manual MULHOLLAND OUTBACK

[. . . ] Skeletal alignment can also be improved through the interactive use of a variety of available postural supports. This manual was developed to provide information on basic utilization of the Outback system. It does not cover all possible variations of components and needs which may exist. [. . . ] To increase the length, remove screws fro top of base, slide to desired length (Both Sides), and replace screws. (Below) 15 Outback System Outback System System Adjustments I. Tilt-N-Space - Using Step Tilt Pedal located on right side (users right side), depress this lever. Once the desired angle is acheived, release the foot pedal to set at desired angle. Step Tilt Pedal Release Pedal Set to Desired Angle Assembly Instructions II. Height Adjustment - Use Foot Pedal at Rear on the Left Side (User s Left) to control the height of the system. While pedal is depressed, you can change the height of the system by pushing forward, or to the rear with the push handle. ** NOTE: Be sure to check box for small parts or screws that may be needed in the assembly of this unit!! I. Pins , loacted at the bottom of each back bars, will click into place when back is fully upright. (Continued on next page) **NOTE : While changing height of system, the angle must also be changed while adjusting. To lower system, tilt system forward first, then decrease height. 7 Mulholland Positoning Systems Inc. Mulholland Positoning Systems Inc. Assembly Instructions I. Adjusting Armrest Angle - Adjut angle of armrest by pushing forward on knob located on botton of armrest. Release this knob to it s rear position to re-engage at desired angle. Assembly Instructions IIV. The push handle has a small push button at the bottom of the tubing. C. Armrest and Tray Assembly Features: - The tray bars are depth adjustable. By depressing the push button on the side of the armrest, you can slide the tray bars in and out to set at desired depth. When desired depth is acheived, you can attach the tray to the tray bars by pulling out on the pull ring while attaching to the bars. The tray mounts on the rear of the back when armrests and tray is not in use. [. . . ] Locate Seat Attachments ( Hanger Nuts ) - The seat is attached in front by connecting hooks on bottom of seat to the hanger nuts on the seat rails. When hooks are attached to both sides, pull cable on botton of seat at rear to engage rear of seat into the rear Receiver Nuts similar to the Hanger Nuts . Assembly Instructions III. Locate Back Attachments - Using the same method used to mount the seat assemblylocate the seat hooks on rear of the back assembly. REAR VIEW B. [. . . ]