User manual MR COFFEE EXP3

[. . . ] OPERATING INSTRUCTIONS FOR THE EXPERT Electronic Drip Coffeemaker by Mr. Coffee brand filters which have the fast flow rate required by The Expert's electronic brewing cycle. Use of the wrong filter may cause coffee to overflow the filter during brewing. /- IMR. C~FEE I `InIimm cc F O R , , , , , hHOLD USE ONLY IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/ or injury to persons, including the following: 1. [. . . ] Because of the speed of this machine, other paper filters may cause beverage to overflow the filter during brewing. Place coffee into the filter according to the coffee measurement chart below. COFFEE MEASUREMENT CHART For best results, use level tablespoons (tbls. ) of drip grind or grind recommended for automatic drip coffeemakers. Fill the decanter with tap water to desired capacity as marked on the side of the decanter, 1 cup = 5 ounces. Depress the SELECT button twice to set the coffeemaker to "Brewer On". The "Brewer 0n"light will glow to signal that the coffeemaker is brewing. Be sure to put the water in the coffeemaker first, before selecting "Brewer On". To prevent damage, the machine will shut off if you have selected "Brewer On" and there is no water in the machine. The brewing cycle is completed when the "Brewer On" light goes off and the "Warmer On" light is on. Note: The adjustable temperature warmer plate will keep your coffee at the temperature you select for up to five hours. For normal usage, always keep the red dot on the temperature dial knob within the red temperature range. The setting of the temperature dial may affect the automatic shut off of The Expert. If the temperature setting is too high, The Expert may shut off prematurely. If the temperature setting is too low, The Expert may not shut off when the decanter is removed from the warmer plate. Refer to the Warmer Plate Temperature Dial and Intelligent Automatic Shut-Off instructions for further information. To make another pot of coffee, turn the coffeemaker off by depressing the SELECT button until all operating lights are off. Note: If the cleaning light is on, this indicates that your coffeemaker needs cleaning. Simply depress the SELECT button until all operating lights are off. The Warmer Plate Temperature Dial The warmer temperature dial on this coffeemaker was preset at the factory to keep your coffee at approximately 185 degrees. On most machines, the red dot on the dial will point to the 1 o'clock position. This temperature is hot enough for most people, and will preserve good flavor. Higher temperatures cause more rapid flavor breakdown, and risk scalding. If the temperature setting is high enough to cause a burnt flavor, the coffeemaker will automatically shut off, prematurely. [. . . ] I just cleaned my coffeemaker and the cleaning light is on: Repeat the cleaning process. l . l l Avoid areas of the coffeemaker which may become hot or emit steam when the machine is "on", particularly the brew funnel and the intake screen. Unplug unit when not in use. 0 Unplug the unit when wiping the exterior. 0 Always remove the decanter before removing the brew funnel and replace the brew funnel before replacing the decanter. Don'ts. . . . . 0 Do Not place a cloth or otherwise restrict airflow beneath the appliance. [. . . ]