User manual MINOURA HYPERBRAIN

[. . . ] To use the plastic Handlebar Mount, remove the bolt and the vinyl cap then coil the band around your handlebar or somewhere with the same diameter. Put the supplied rubber pad between the band and the handlebar if you need. Tighten the bolt firmly and simply slide the Main Unit into the Base until click. [. . . ] (When the two buttons are pressed in "O" mode, the wheel circumference stored will be displayed. ) ALL CLEAR When the AC button on the backside of the computer is pressed, all data stored in memory (trip distance, speed scale, wheel circumference and clock time) will be erased. All displays illuminates, then the "mile/h" symbol alone appears. This operation should be executed only when irregular display occurs or no display appears. Since all the memories are erased, set the main unit again according to "Main Unit Preparation". MAIN UNIT PREPARATION The following must be completed before operation. This battery is just for checking the function of the unit so it may only last a short period of time. Setting Speed Scale Press AC button on the backside of the Main Unit to clear all data. Then "mile/h" alone will be displayed, "km/h" and "mile/h" are alternately displayed each time when the Start/Stop button is pressed. Setting the wheel circumference The figures "2155" (standard wheel circumference for 27") will flicker. This is just a guideline so you have to adjust this number to the exact size of your rear wheel. If you are going to use HyperBrain on HyperMag or HyperRim, set this number as "117" (the circumference of the drive roller of your Hyper series resistance unit). To revise "2155" to any number, press the Mode button to decrease the number one by one. Current Speed and Elapsed Time will be displayed, then the figure you selected will be set. Setting the 24-hour clock time Set the main unit in the clock mode by pressing the Mode button for over 2 seconds. How to replace the battery If the display becomes invisible from the front, it is time for replacing battery. Prepare a new battery (CR2032) in advance, before taking out the old battery. When replacing, be careful not to press the AC buttons, and replacement must be done promptly (within 20 seconds). After replacement, don't press AC button, because the data including total distance (odometer) is continuously measured, and AC button will set all data erased. However, the following malfunction might occur after replacement: ·No display appears. [. . . ] You don't need to press the Start/Stop button each time when the Auto function is switched on. To switch on/off the Auto function, set the main unit in the (T), (D), or (A) mode. Press the Set button and the Auto function will be switched on/off each time the button is pressed. [. . . ]