User manual MIDLAND LXT435

[. . . ] (Tested with Headset Model: AVP-1) Page 3 www. midlandradio. com Model LXT210/216/303/305/310/350/410/435 Series ® IMPORTANT NOTICE, FCC LICENSE REQUIRED FOR GMRS OPERATION The LXT210/216/303/305/310/350/410/435 Series operates on GMRS (General Mobile Radio Service) frequencies which require an FCC (Federal Communications Commission) license. You must be licensed prior to operating on channels 1 - 7 or 15 - 22, which comprise the GMRS channels of the LXT210/216/303/305/310/350/410/435 Series. Serious penalties could result for unlicensed use of GMRS channels, in violation of FCC rules, as stipulated in the Communications Act's Sections 501 and 502 (amended). You will be issued a call sign by the FCC which should be used for station identification when operating the radio on GMRS channels. [. . . ] The RX icon will appear on the display when your radio is receiving a transmission. ABOUT RANGE Your LXT Series radios are designed to give you maximum range under optimum conditions. Optimum Conditions are: l Over water l Open rural areas without obstructions l Flat areas where you can see the other person To ensure you get maximum range: l Be sure to use fresh or fully charged batteries - low batteries will cause low power conditions l Be sure you are on a GMRS channel - FRS channels are restricted by the FCC to low power l Be sure to set your radio to use Hi power. Page 8 www. midlandradio. com Model LXT210/216/303/305/310/350/410/435 Series ® LXT210/216/303/305 SERIES QUICK REFERENCE CHART MENU Channel Power Roger Beep 1~22 H/L On/Off LXT310/350/410/435 SERIES QUICK REFERENCE CHART MENU Channel Privacy Power eVOX Vibrate Roger Beep Call Tone Silent Operation WX Band 1~22 WX Channel Press Menu button when WX Band is ON oF~38 H/L oF/1/2 On/Off LXT410/435 Series only On/Off **1~5 **LXT410/435 Series only **LXT310/350 Series : 1~3 On/Off On/Off 1~10 MONITOR (LXT310/350/410/435 Series only) Pressing and holding the MONITOR button for 1 second will let you hear noise so you can adjust the volume level of the radio when not receiving a signal. This should be used to check activity on your current channel before transmitting. Press and hold the MONITOR button for 1 second again to get out of MONITOR mode. SCAN Your LXT210/216/303/305/310/350/410/435 Series can scan all 22 channels for activity. Your radio will rapidly scan each of the 22 channels and stop on any active channel for 5 seconds before resuming scan. When you press the PTT button to transmit on an active channel, the scanning function will stop and remain on the active channel. To resume scanning, quickly press the SCAN button. Page 9 www. midlandradio. com Model LXT210/216/303/305/310/350/410/435 Series ® CALL TONE Your LXT210/216/303/305/310/350/410/435 Series can transmit a call tone for a fixed length of time. The TX icon will appear while transmitting a call tone and a tone can be heard on the speaker for confirmation. KEYPAD LOCK To avoid accidentally changing the radio setting, press the LOCK button for 4 seconds. CHANNEL SELECTION (GMRS/FRS BAND) Press the MENU button once, and then the / buttons to select one of the 22 GMRS/FRS channels. The display shows "VOX" blinking while on the right of the CHANNEL NUMBER display, a "1" or "2" icon appears. Select "oF" by pressing the / buttons and push the PTT key, or press MENU button again to move to the next feature setting. www. midlandradio. com Page 11 Model LXT210/216/303/305/310/350/410/435 Series ® VIBRATE ALERT (LXT410/435 Series only) To turn the VIBRATE ALERT on, press the MENU button five times so the display will show the VIBRATE-ALERT icon blinking, while on the right of the CHANNEL NUMBER, an "oF" icon appears. Select "on" by pressing the / buttons and push the PTT button, or press MENU button again to move to the next feature setting. To turn the VIBRATE ALERT off, press the MENU button five times, so the display will show the VIBRATE ALERT icon blinking, while on the right of the CHANNEL NUMBER, an "on" icon appears. Select "oF" by pressing the / buttons and push the PTT button, or press MENU button to move to the next feature setting. ROGER BEEP (end of transmission) TONE When the PTT button is released, the radio will beep to confirm to other users that your transmission has finished. To turn the ROGER BEEP tone on, press the MENU button until the display shows an "rb" icon while on the right of the "rb" display, an "oF" icon appears. Select "on" by pressing the / buttons and push the PTT key, or press MENU button to move to the next feature setting. To turn the ROGER BEEP tone off, press the MENU button until the display shows an "rb" icon while on the right of the "rb" display, an "on" icon appears. [. . . ] Performance of any obligation under this warranty may be obtained by returning the warranted product, freight prepaid, along with proof of purchase to: Midland Radio Corporation Warranty Service Department 5900 Parretta Drive Kansas City, MO 64120 This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. Note : The above warranty applies only to merchandise purchased in the United States of America or any of the territories or possessions thereof, or from a U. S. Midland Radio Corporation 5900 Parretta Drive Kansas City, MO 64120 Tel: (816) 241-8500 E-mail: mail@midlandradio. com URL: www. midlandradio. com Page 17 www. midlandradio. com Model LXT210/216/303/305/310/350/410/435 Series ® ACCESSORIES Accessories can be purchased at www. midlandradio. com or fill in the form on the following page and mail it to our address. Headsets w/ PTT - $19. 95 AVP-4 1 Dual Desk Charger 2 Rechargeable battery packs 1 AC Adapter 1 DC Cigarette lighter adapter - $39. 95 Page 18 www. midlandradio. com Model LXT210/216/303/305/310/350/410/435 Series ® ACCESSORIES ORDER FORM Please send Money Order or fill in Visa/MasterCard information and mail to the address below. [. . . ]