User manual MAXELL DLT TAPE CLEANING CARTRIDGE DLT

[. . . ] DLTtape Cleaning Cartridge TM WHEN TO USE CLEANINIG CARTRIDGE If the `Use Cleaning Tape' light is ON, then the DLT drive's read/write heads need cleaning. 1/2 Instruction manual CARTRIDGE HANDLING Handle the cleaning cartridge carefully. [. . . ] When the tape is ready to clean, the `Tape in Use' light (yellow) comes on steady, and cleaning begins automatically. When the `Use Cleaning Tape' light (orange) shuts OFF, a cleaning cycle is complete. · If the `Use Cleaning Tape' light remains ON, then a cleaning cycle has NOT been done, and the cleaning cartridge is expired and must be replaced. REMOVING THE CLEANING CARTRIDGE FROM THE DLT DRIVE · When the `Operate Handle' light (green) is ON, pull the handle up to the open position to remove the cleaning cartridge. · Remove the cleaning cartridge and push the handle down to the closed position. · After each cleaning cartridge use, follow the instructions shown on the Front Slide Label. USING CLEANING CARTRIDGE WITH DLT MAGAZINE TAPE SUBSYSTEMS · If `Use Cleaning Tape' light is ON, insert the cleaning cartridge into magazine slot, load the magazine, and manually select the slot which has the cleaning cartridge. The cleaning cartridge will load and cleaning will begin automatically. · When `Use Cleaning Tape' light shuts OFF, a cleaning cycle is complete. To remove the cleaning cartridge from the subsystem, press the `Eject" button, remove the magazine from the subsystem, and remove the cleaning cartridge from the magazine. [. . . ] · Contents of this website are subject to change without notice. [. . . ]