User manual MARANTZ PM-17MKII
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MARANTZ PM-17MKII. We hope that this MARANTZ PM-17MKII user guide will be useful to you.
Manual abstract: user guide MARANTZ PM-17MKII
Detailed instructions for use are in the User's Guide.
[. . . ] Model PM-17mk2 2 Integrated Amplifier
ENGLISH
WARRANTY
Contact your local Marantz distributors for warranty information.
ESPAÑOL
GARANTÍA
Consulte a su distribuidor local de Marantz si desea más información sobre la garantía.
RETAIN YOUR RECEIPT AS PROOF OF PURCHASE
Your receipt is proof of a valuable purchase. Keep it in a safe place where you can easily find it for filing insurance claims when necessary or when corresponding with Marantz.
CONSERVE EL RECIBO COMO PRUEBA DE COMPRA
Su recibo constituye la prueba de compra. Guárdelo en un lugar seguro donde pueda hallarlo fácilmente en caso de que lo necesite para presentar una reclamación de garantía o mantener algún tipo de correspondencia con Marantz.
IMPORTANT
It is the responsibility of the consumer to establish proof of purchase when seeking servicing covered by the warranty. Your receipt or invoice is valid as such proof.
IMPORTANTE
Es responsabilidad del consumidor presentar la prueba de compra siempre que solicite alguna reparación cubierta por la garantía. [. . . ] Usage example 1: Bi-amp connection combined with Marantz SM-17 (main amp)
SPEAKERS SPEAKERS IMPEDANCE L+R:4-8 OHMS BTL:8-16 OHMS
R
L
BTL
INPUT SELECTOR CD INTEGRATED AMPLIFIER PM-17 PHONO LINE 1 27 VOLUME 20 15
LINE 2
35
13
LINE 3 TEMP
43
10
CD-R
58
4
REC SELECTOR
TAPE PHONES
CD-R TAPE
LINE 1 LINE 2
SPEAKERS 2
0 2 2
0 2
8
CD
POWER
BASS
TREBLE
BALANCE
0 (-dB) SOURCE DIRECT
COPY
LINE 3
4
4
4
4
PHONO
-6 ON OFF
(dB)
6+
-6
(dB)
6+ LEFT RIGHT ON OFF
L
L
L SEPARATE
R PRE OUT MAIN IN
R COUPLED
L (BTL) ATT R
R+
L+
Set the switch to NORMAL.
RNORMAL BTL
L-
Set the switch to 0 (dB).
0 -6 (dB)
R BTL OUT
L
INPUT
POWER AMPLIFIER SM-17
TEMP
HF
POWER
HF LF
LF
R
L
BTL
SPEAKERS IMPEDANCE L+R:4-8 OHMS BTL:8-16 OHMS SPEAKERS
If you are using a speaker system that supports bi-wiring, you can combine the PM-17mk2 with the SM-17 for bi-amp operation that provides a higher quality of sound. Please refer to the user guide of SM-17.
INPUT SELECTOR CD INTEGRATED AMPLIFIER PM-17 PHONO LINE 1 27 VOLUME 20 15
LINE 2
35
13
LINE 3 TEMP
43
10
CD-R
58
4
REC SELECTOR
TAPE PHONES
CD-R TAPE
LINE 1 LINE 2
SPEAKERS 2
0 2 2
0 2
8
CD
POWER
BASS
TREBLE
BALANCE
0 (-dB) SOURCE DIRECT
COPY
LINE 3
4
4
4
4
PHONO
-6 ON OFF
(dB)
6+
-6
(dB)
6+ LEFT RIGHT ON OFF
L
L SEPARATE
R PRE OUT MAIN IN
R COUPLED
Set the switch to SEPARATE.
LINE IN L OUT IN TAPE OUT L
R
R
Graphic equalizer
L
R
3
DANSK
SVENSKA
PORTUGUES
Usage example 2: Graphic equalizer connection
ITALINO
ESPANOL
NEDERLANDS
Set the switch to COUPLED.
R
DEUTSCH
FRANCAIS
ENGLISH
ENGLISH FRANCÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALINO PORTUGUÊS SVENSKA DANSK
NAMES OF CONTROLS AND INDICATORS
(Figure 2)
A GND (GROUND) terminal
Connect the grounding wire from the Analog turntable to this terminal.
When the INPUT SELECTOR is set to PHONO, the type of cartridge used on the turntable can be selected between MM (Moving Magnet) and MC (Moving Coil) using this switch. MM (Moving Magnet) Set the switch to the out MC (Moving Coil) )position.
M AC IN jack
Connect to AC power outlet. This unit can be powered by 230V AC only.
set the switch to the in ( )position.
Selects the program source to be produced, from PHONO, CD, LINE 1, LINE 2, LINE 3, CD-R and TAPE.
C PHONO INPUT jacks
Connect the output jacks of the Analog turntable to these jacks. D CD PLAYER INPUT jacks Connect the output jacks of a Compact Disc player to these jacks.
w VOLUME control
Turn the knob to adjust the volume. The volume up-down operations can also be controlled from the provided remote control unit.
E LINE 1 LINE 3 INPUT jacks
These are LINE 1 LINE 3 input jacks which can be used to connect the audio outputs of AV components such as TV multiplex/stereo audio turners, VCRs, and leaserdisc players.
e PHONES jack
This jack accepts the standard stereo phone plug of headphones.
F CD-R IN/OUT jack
r REC SELECTOR switch
Connect the line output jacks and line input jacks of CD recorder to these jacks.
G TAPE IN/OUT jacks
Connect the play (output) jacks and record (input) jacks of tape decks to these jacks.
t SPEAKERS switch
Press to switch the speaker systems ON (pressed-in position) and OFF (out position). Set the switch to OFF (out position) when you listen through headphones only.
Output jack for connection to extension power-amp, mixer or similar.
y IR SENSOR
The unit receives the infrared remote control signal through this window. Point the transmitter of the remote control unit toward this window to send correct remote control signals.
I MAIN IN jacks
Connect the pre output jacks of your pre-amp to these jacks at the SEPARATE position of the selection switch J.
u POWER switch
Press to turn power ON and press again to turn it OFF. The pointer LED of the INPUT SELECTOR switch q also lights when the power is ON and goes out when it is OFF.
J SEPARATE/COUPLED selection switch
The initial setting of the selection switch is COUPLED position. Set according to the SEPARATED position, this unit is possible to use pre-amp or power-amp.
i Tone (BASS, TREBLE) controls
Turn the knobs to adjust the tone. Turning a knob controls the level of the corresponding frequency range. Turning each control toward "+" boosts the corresponding frequency range and toward " " attenuates it. BASS: Controls the tone of low frequencies.
Connect your speaker system to these terminals.
4
DANSK
SVENSKA
K SPEAKER Terminals
PORTUGUES
ITALINO
H PRE OUTPUT terminal
ESPANOL
Selects the COPY mode between CD recorder and TAPE deck, or the signal to be output to the OUT jacks of CD-R and TAPE.
NEDERLANDS
DEUTSCH
q INPUT SELECTOR switch
FRANCAIS
B MM/MC SELECTOR switch
(REMOTE CONT. BUS) By connecting this unit with a MARANTZ component equipped with the remote control (D-BUS) jacks, both components can be remote controlled as a system. For details of the remote control function, read the owner's manual of the connected component. The bus OUT terminal is used to send signals to another item of equipment. The bus IN terminal is used to receive signals from another item of equipment.
ENGLISH
ENGLISH FRANCÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALINO PORTUGUÊS SVENSKA DANSK
L REMOTE CONTROL BUS terminals
Turn to correct the left-right imbalance which may occur in stereo broadcast reception or otherwise change the output level of either the LEFT or RIGHT channel. Be careful of the position of this control because turning it fully clockwise or counterclockwise mutes the sound from the other channel.
When this switch is pressed in, the signals are transmitted by bypassing the BALANCE and tone (BASS and TREBLE) control circuitry so that they can be reproduce with a higher quality. (The BALANCE, BASS and TREBLE controls are defeated. )
!1 Warm-up meter
With any audio unit, the real sound quality cannot be obtained immediately after the power is turned on, and warming up is required to make the unit exhibit its full performance. As time passes after the power has been turned ON, the temperatures of different parts of the unit become constant and the electrolytic capacitors become active. The meter needle starts to swing gradually in a little while after the power is turned ON and reaches about 2/3 of the meter's full scale in about 30 minutes. Now the unit has almost been warmed up and can reproduce music with its original performance. [. . . ] Corel2 Marantz Professional Products Marantz Professional Products Almana & Partners W. W. L. Vision + Alltrom SRL Trade Company SV Ultimate Fidelity Forward Marketing (S) Pte. ITM Marantz Trading
ADDRESS 4 Station Street, Thornleigh NSW 2120, Australia Taborstraße 95 / Ladestraße 1, Gebäude Hangartner, A-1200 Wien, Austria Brusselbaan 278, 9320 Erembodegem, Belgium Makedonia Blvd. Box 5604, Nicosia, Cyprus Fugnerova 1, 67801 Blansko, Czech Republic Aboulevarden 1, DK-8000 Arhus C. , Denmark P. O. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MARANTZ PM-17MKII
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MARANTZ PM-17MKII will begin.