User manual LIFT-MASTER BWCAMKIT

[. . . ] CCTV CAMERA KIT INSTALLATION INSTRUCTIONS These instructions cover the installation of the black/white & color CCTV Camera Kit in Sentex Crown Jewel and Infinity systems equipped for CCTV. INSTALLATION 1 2 3 4 5 6 Remove power to the unit. [. . . ] 9 Secure CCTV board to front panel using femalefemale standoffs (previously removed). Carefully snug with 3/16" nut driver. WIRE DISTANCE SPECIFICATIONS Power Wire Distance: Up to 100 Feet Video Cable Distance: Up to 1000 Feet (max length based on monitor with . 25 volt p-p. composite signal sensitivity) PARTS SUPPLIED Part Number SN1600009 SN1600008 SN5300059 SN5600036 SN6001576 Qty. (Black & White) 12V 20VA Transformer Right-Angle BNC Connector Installation Instructions 7 8 PARTS NOT SUPPLIED AC/DC Power Wire: 18 AWG, 2 conductor cable Video Wire: Single conductor 75 ohm RG-59U coaxial cable (Belden #9240 or equiv. ) with BNC connectors (Amphenol #31-71008 or equiv. ) CCTV Monitor (or television with video input). 10 Connect coaxial cable with BNC connector to J2 BNC connector on CCTV board. 11 Connect the power wire to terminal block TB1 (see Figure 2): Lift blue terminal block off TB1 terminal pins. Insert wire into opening on front and tighten screw until wire is held firmly. [. . . ] The video signal is continuously available at J2 on the CCTV interface board. Doc 6001576, Rev A Page 2 of 2 Figure 1: Mounting the CCTV Board Figure 2: Power and Video Connections TEST AND ADJUSTMENT 1 2 3 4 5 Plug in AC power supply. [. . . ]