User manual LIFT-MASTER 376LG

[. . . ] Model 376LG 315 MHz Security® Wireless Keyless Entry WARNING To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · Install door control within sight of gate or garage door, out of reach of children at a minimum height of 5 feet (1. 5 m), and away from all moving parts of gate or door. · NEVER permit children to operate or play with gate or door control push buttons or remote control transmitters. · Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. [. . . ] Enter a four digit personal identification number (PIN) of your choice on the keypad. While holding the ENTER button, press and hold the LIGHT button on the Multi-Function Door Control. Continue holding the ENTER and LIGHT buttons while you press the push bar on the Multi-Function Door Control (all three buttons are held). Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad. If light bulbs are not installed, two clicks will be heard. LOCK LIGHT LOCK LIGHT Side two contains instructions for installing the Keyless Entry, changing the personal entry password and setting a temporary password. 1 INSTALLATION Choose a convenient location for installation. Exterior Front Wall Install out of the reach 1-Piece or of children at a Sectional Door minimum height of 5 Door Jamb Edge feet (1. 5 m), away from (Optional Location all moving parts of door. for 1-Piece Door) For a one-piece door, Door Jamb Face choose the optional SECTIONAL DOOR ONLY location shown in the KEYPAD MUST BE INSTALLED illustration to avoid WITHIN SIGHT OF THE DOOR injury as the door swings up and out. Test the reception of the Keyless Entry by operating your opener from the selected location. Remove the battery compartment Bottom cover to access the bottom mounting hole mounting hole: · Insert a small phillips screw driver Battery into the small hole at the bottom of Battery the cover and gently pull Cover outward to loosen. Mark 4-1/4" up the centerline from the bottom and drill a 1/8" pilot hole. Install top mounting screw, allowing 1/8" to protrude above surface. With cover open so bottom mounting hole is visible, use a punch to mark hole. Replace keypad and complete installation with bottom screw, using care to avoid cracking plastic housing. To replace the battery cover, insert the lip at the top and snap in place. Keypad Typical Installation TO CHANGE AN EXISTING, KNOWN PIN If the existing PIN is known, it may be changed by one person without using a ladder. Press the four buttons for the present PIN, then press and hold the # button. The door should move. TO SET A TEMPORARY PIN You may authorize access by visitors or service people with a temporary 4-digit PIN. [. . . ] It WILL NOT work on keypads programmed to an external receiver. THE KEYLESS ENTRY BATTERY WARNING To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. Dispose of old batteries properly. WARNING CAUTION WARNING The temporary password will continue to CLOSE the door even after the time has expired. 1-800-528-2817 AVERTISSEMENT ATTENTION AVERTISSEMENT AVERTISSEMENT 114A3175B © 2006, The Chamberlain Group, Inc. [. . . ]