User manual LG VC9430SH

[. . . ] All safety messages will follow the safety alert symbol and either the word "WARNING" or "CAUTION. This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death. This symbol will alert you to hazards or unsafe practices which could cause bodily injury or property damage. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] You should grasp the carrier handle when you are moving the vacuum cleaner. Make sure the filters (exhaust filter and air filter) are completely dry before replacing in the machine. If the power cord is damaged, it must be replaced by an approved LG Electronics Service Agent to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor overheating. If the vacuum cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner. Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minute period, plug the vacuum cleaner back in and turn on the switch. If the vacuum cleaner still does not run, contact a qualified electrician. Connecting the hose to the vacuum cleaner Raccordement du flexible à l'aspirateur Push the fitting pipe on the flexible hose into the attachment point on the vacuum cleaner. To remove the flexible hose from the vacuum cleaner, press the button situated on the fitting pipe, then pull the fitting pipe out of the vacuum cleaner. Pull out the power cord to the desired length and plug into the socket. Always empty the dust tank when the dust tank level reaches the MAX line. To store during vacuuming, for example to move a small piece of furniture or a rug, use park mode to support the flexible hose and nozzle. - S lide the hook on the nozzle into the slot on the side of vacuum cleaner. When you have switched off and unplugged the vacuum cleaner, press the cord reel button to automatically rewind the cord. You can store your vacuum cleaner in a vertical position by sliding the hook on the nozzle into the slot on the underside of the vacuum cleaner. How to use Using all floor nozzle and mini turbine nozzle Utilisation Utiliser la brosse Turbo-combi et la brosse mini turbine The 2 position nozzle This is equipped with a pedal which allows you to alter its position according to the type of floor to be cleaned. Carpet or rug position Press the pedal ( ), then brush is will rotate ?Hard floor position Press the pedal ( ) , then brush will stop rotating Open the cover by pulling the hook. [. . . ] Since this vacuum nozzle has been made exclusively for cleaning beds, blankets and upholstery, use it only for these cleaning purposes. (Using it to clean the floor may result soiling it or a drop in performance, do not use it for such purposes. Press the button on the rear side of the vacuum nozzle to separate the bottom plate. Insert the attachment projections on bottom plate to the vacuum nozzle grooves. [. . . ]