User manual LG F1088LD

[. . . ] Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. Should this happen, unplug or main switch off the unit and contact an authorized service center. Do not insert anything between the air outlet blades because the inner fan may be damaged and could cause injury. Should this happen, switch off the breaker used for your air conditioner and contact your installation specialist. [. . . ] The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes. IMPORTANT 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Result: Note The indoor unit beeps each time you press the The air conditioner runs in the Heat mode. button. 3 To adjust the temperature, press the button one or more times until the required temperature is displayed. Result: Each time you press the button: - The temperature is adjusted by 1C - The indoor unit beeps If the room temperature reaches the set temperature (selected temperature+5C), the air conditioner stops heating, but the fan is still operating. The air conditioner starts heating, provided that the room temperature is lower than the desired temperature (selected temperature+3C). button one or more times ) 4 Select the fan speed by pressing the until the required setting is displayed: Automatic (rotated : Low Medium High Maximum Result: Each time you press the button, the indoor unit beeps. For the first three to five minutes, the fan operates very slowly until the air has been sufficiently warmed. Once the correct temperature has been reached, the fan is automatically set to the required speed. 5 To control the direction of the air flow, refer to pages 16 and 17. E-11 Removing Excess Humidity If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: button. The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode selected when the unit was last used. The air conditioner will switch off automatically when the counter displayed on the remote control reaches the set time and disappears the Off Timer setting. Example If you would like to turn the air conditioner on after 2 hours and to operate it for 2 hours: 1. button. You can see or change the setting mode and/or the temperature by pressing the button or the button after setting the Off Timer. To Cancel the Off Timer If you no longer wish to use the Off Timer that you have set, you can cancel it at any time. If you want to turn off the air conditioner before the timer reaches the setting time, press the button. E-19 Setting the Sleep Timer The Sleep Timer can be used when you are cooling or heating your room to switch the air conditioner off automatically after a period of six hours. Note If you wish to switch the unit off at a specific time, refer to page 19. 1 2 Make sure that you have selected either the Cool or Heat mode. The air conditioner will be controlled as indicated in the illustrations below. Cooling The desired temperature is increased by 1C every hour. When it has been increased by 2C (after two hours), the temperature is maintained for four hours. Heating The desired temperature is decreased by 1C every hour. When it has been decreased by 2C (after two hours), the temperature is maintained for four hours. To Cancel the Sleep Timer If you no longer wish to use the Sleep Timer that you have set, you can cancel it at any time. The air conditioner operates normally. E-20 Setting the 1 Hour Timer ENGLISH The 1 Hour Timer enables each mode to operate only for an hour and stop automatically with just one touch of the 1 Hour Timer button. It is good for you when you feel setting the Off Timer by pressing the Off Timer button several times is unnecessary and inconvenient. The air conditioner will stop operating after an hour automatically. 2 To select an operating mode under the set 1 Hour Timer, press the button until the desired mode is displayed at the remote control. Result: The air conditioner will run and stop operating in the selected mode with the 1 Hour Timer set. Note If you operate the 1 Hour Timer when the air conditioner is turned off, the air conditioner will start operating and be turned off after an hour. To cancel the 1 Hour Timer If you no longer wish to use the 1 Hour Timer that you have set, you can cancel it at any time. [. . . ] The automatic protection feature may be triggered and the air conditioner stopped. A water leak or some other malfunction may occur if the heat exchanger freezes. Water may condense on and drip from the surface of the indoor unit if it is used for long periods. Indoor Humidity 80% or less - Outdoor Temperature 0C to 24C approx. [. . . ]