User manual LG AN-MR200

[. . . ] OWNER'S MANUAL MAGIC MOTION REMOTE Please read this manual carefully before operating your set and retain it for future reference. AN-MR200 Remote control (AKB732955) RF Dongle (EAT614134) www. lg. com 2 ACCESSORIES ENERGY AV MODE INPUT TV SAVING 1 4 7 LIST 2 5 8 0 MARK 3 6 9 FLASHBK VOL ENTER 3D MUTE FAV CH P A G E MENU INFO Q. MENU VOL ENTER CH BACK MUTE EXIT L/R SELECT FREEZE RATIO Magic Motion Remote Control Owner's manual and Batteries (AA) RF Dongle RF Dongle Cable Strap Velcro REMOTE DESCRIPTION Pointer (RF transmitter) Blinks the light when operating. POWER Turns the TV on or off. Home Home Accesses the Home menu. Home ENTER/OK Selects menus or options and confirms your input. [. . . ] *To avoid wireless interference, keep the distance between the RF Dongle and the Wi-Fi dongle at 20 cm. 1 Locate the designated Velcro attachment location on the TV. (The attachment location is different depending on the TV model you own) Velcro 20cm or RF SPECIFICATION The Magic Motion Remote Control communicates with RF Dongle using a 2. 4 GHz bandwidth radio frequency (RF). *Attach the RF Dongle aligning with the upper left corner bracket. 2 Connect the RF Dongle Cable plug on the RF Dongle to a USB1 jack on the TV. Output: 1 dBm or lower Maximum Communication Distance: 10 m (32. 8 ft) in an open space Bandwidth: 2. 4 GHz (2. 4035 GHz - 2. 4783 GHz) Transfer Rate: 250 kbps 4 REGISTERING The Magic Motion Remote Control operates by pairing with your TV. How to register the Magic Motion Remote Control To register the remote control, press the ENTER (or OK) button on the remote control while aiming it at your TV. How to Re-register the Magic Motion Remote Control after Registration Failure Reset the remote control by pressing and holding both the ENTER (or OK) and MUTE buttons for 5 seconds. (Once the reset is complete, the light on the Pointer blinks. ) Then repeat the above procedure to register the remote control. PRECAUTIONS TO TAKE ENTER OK ENTER OK MUTE HOW TO USE ENTER OK Press ENTER (or OK) button if there is no pointer on your TV screen. If the pointer has not been used for a certain period of time, it will disappear. You can move the pointer by aiming the front of the remote control at your TV then move it left, right, up or down. If the pointer does not work properly after clicking the ENTER (or OK) button, wait for 10 seconds then use it again. Use the remote control within the maximum communication distance (10 m, 32. 8 ft). [. . . ] If the AP is installed closer than 1 m, the magic motion remote control may not perform as expected due to frequency interference. [. . . ]